How to SHUT OFF your check engine light - Nissan Sentra, Versa, Rogue

Watch until the end, this does work to both read and reset your SES light.
Read the codes from your cars computer and reset your service engine soon and check engine soon light without any special tools.
Do NOT have the engine running during this procedure or you will damage your engine.
This has been tested on Nissan’s from approx 2004-2016 and have had successful results. Make sure to use a timer if you can’t get the timing right.
These are the steps you need to remember:
-Turn ignition switch to on position but do not start vehicle
-Count to 3, and press and release the gas pedal 5 times fast
-Count to 10, push the gas pedal all the way to the floor and hold it there
-Count to 12, release the gas pedal completely
-Count to 10, push gas pedal fully to the floor and hold or
-Count to 10, release gas pedal completely
-Turn ignition to OFF position, wait approximately 5 seconds
-Start vehicle….codes will be cleared.
Do NOT have the engine running during this procedure or you will damage your engine.
Video first shows the steps to this process then explains the steps. Then I show how to check the codes and then show you how to clear those codes.
CORRECTION TO VIDEO: I mentioned that I use a K&N oil filter, but I was actually meaning the K&N reusable AIR FILTER. These are fairly easy to over oil, and then the oil sucks from the air filter onto the MAF (Mass Airflow Sensor) causing a fault and a SES light to come on.