Tilta Nucleus Nano Wireless Lens Control System Quick Setup
Vložit
- čas přidán 4. 09. 2024
- IPG Team Member Chris demonstrates the setup for the new Tilta Nucleus-Nano Wireless Lens Control System.
If you like to rent this gear, please click the link below:
www.ipgrentals....
Sending one back since the controller screen is so dim you can't read it.
Unfortunately we had to do the same thing
Have you ever encountered the problem where the screen on the wheel is dim? I'm at a loss. My battery is full. Can't seem to find a display brightness feature
Me too, I just got it and it is going back since you can just barely make out the number but can't read the font at all.
Yes unfortunately we did as well we had to send it in for repair
Thank you for the review. I still don’t understand why there is no internal power for the motor.
You mean instead of running on battery?
IPG Rentals Yes. And it is unfortunate that I don’t use gimbal that much. As opposed to Nucleus N, the PD movie one has an internal rechargeable battery. Of course it is more expensive that Nucleus N...😭
IPG Rentals the motor does not run on a battery
Yes the motor does run on a special battery
IPG Rentals the focus wheel, but the motor does not. What battery are you referring to? I have the same unit and the motor connects via USB to a power source. There is no replaceable battery in the motor that turns the lens gears.
hi.i have a issues with this nano motor , actually was working perfect , now impossible calibrate and shoe me a message , MOTOR PROTECTION, PLEASE RECAL...... I CHEKED, VOLTAGE,cables,nothing... thanks
We had this issue and we had to send it in for repair
dont mind mentioning that focus does not work on fly by wire lenses
Actually, it does work on FBW lenses... sort of, if you don't power cycle the camera or the focus elements.
Great review 👍
Thank you. Glad you enjoyed it. Come back again
Good morning,
Thank you for your valuable information. I just bought the Tilta nucleus Nano, but I have a problem with my Sony (16-35mm/F4 and 24-70mm/F4) Lenses. After calibration, with these two objectives I can not make a stable adjustment of the points A and B, the point will shift each time. With my other objectives (DF) with stop, it works perfectly. Would you have an explanation?
Thank you.
Is your rubber ring sliding? When setting up the points in DSLR lenses it has very little travel from one end to another so that’s weird.
What do you think does it have noise while focusing, what an external mic on the camera would pick up? :) Thanks!
No motors are pretty quiet.
@@ipg_rentals Thank you!
Do you think nano can handle a zoom cine lens & how about the latency compare to moza ifocus system?
There is hardly any latency. We tried it on a couple of our primes and it worked
Hi..How do I can start recording with the rec button? thanks
Unfortunately you can’t with this only if you have the right cable
Unfortunately you can’t. It doesn’t support certain cameras
Any chance you can test this out on a sigma lens? I'm worried they're too tight for the low torque of this setup
I would but we have cannon and Sony lenses.
Sorry
It works fine with Sigma!
Brandon Douglas Thank you for your input Brandon
please tell me how can i connect rec button with camera)
It depends on the camera you have will work with electronics. I’m sure they will have firmware update to use for all cameras
For how long should I keep it on the charger?
Unfortunately it takes a very long time to charge. Just keep leaving it on until it stops blinking.
@@ipg_rentalsRentals oh god, I thought that I had an issue with it! Thank you so much.
Can the motor be powered from GH5S? I don't use gimbal.
Sorry I thought you were talking about the ronin s. The motor is powered by a battery which is provided and WiFi. Hope this helps
IPG Rentals the motor does not come with a battery. The wheel does. The motor is powered by usb or Dtap