Why did you set outdoor unit . To 51. I recently did two branch boxes set first 1 to 0,1 2nd box to 0,4 after using 3 zones in first.. what would out door hyper heat address be and why??
I am confused. You indicate that in addressing the outdoor unit the first digit is set on SWU2 and the second digit on SWU1. The notes on the circuit board clearly indicate the exact opposite. The note nest to SWU1 says first digit and nest to SWU2 as second digit. There were similar instructions for the branch box but I did not see any notes on that circuit board. Please clarify this for me.
It’s easy- you’re basically setting the out door unit to address 51. And you’re setting the branch box to address 01. Each port you activate with them be assigned it’s own address. For example, port A is address 01, port B is address 02, port C is address 03 etc. It goes all the way up to 50 if you had that many units and that many branch box ports
I watch this video every. Time.
Why did you set outdoor unit . To 51. I recently did two branch boxes set first 1 to 0,1 2nd box to 0,4 after using 3 zones in first.. what would out door hyper heat address be and why??
Thank you for the education!
what are the dip setting for puz-a18nka7
Thanks sir also i want be know the heavy industry also please
Great information
Sir pls tell me how to by pass odu vrf
is this branch box upside down ???
Thanks Brada🤙🏼
how do you do this with out a branch box and only a 2 pipe header?
Greetings, please explain how to check numbers of indoors on outdoor units
The indoor units are essentially addressed by enabling them on the sw1 dip switch
I have and IT signal adapter. PAC-IT51AD-E. Do you have a video for this? And PFFY-P-NEMU-E indoor unit
How about SW 1 dip switch 6? Sgould it be on or off?
I am confused. You indicate that in addressing the outdoor unit the first digit is set on SWU2 and the second digit on SWU1. The notes on the circuit board clearly indicate the exact opposite. The note nest to SWU1 says first digit and nest to SWU2 as second digit. There were similar instructions for the branch box but I did not see any notes on that circuit board. Please clarify this for me.
I am right there with you this video makes it more confusing.
it also looks like branch box upside-down or its one of the correct position?
Diagram pls sir
Hola amigo comprende español
don
I’m sorry Jeff. Rotary dial explanation is very broad and confusing.
It’s easy- you’re basically setting the out door unit to address 51. And you’re setting the branch box to address 01. Each port you activate with them be assigned it’s own address. For example, port A is address 01, port B is address 02, port C is address 03 etc.
It goes all the way up to 50 if you had that many units and that many branch box ports