RhinoAg TS10 Rotary Cutter: Setup and Pre-Delivery Procedure

Sdílet
Vložit
  • čas přidán 6. 09. 2024
  • Step by step video guide to the setup and pre-delivery procedure for the RhinoAg TS10 Rotary Cutter.

Komentáře • 6

  • @LGEZ53S
    @LGEZ53S Před 4 lety

    Thanks for the video. All dealers should watch and understand this video. When I picked up my new TS10 yesterday, the wings were drooping when raised, and when I asked the dealer if they leveled the wings, they said they adjusted the links until the wing mounted tires touched the ground when raised....

  • @robertkern6445
    @robertkern6445 Před 4 lety

    There is no way that is that easy to grease those shafts. You come to our house and show us how to do it that easy.

  • @bearkatljl
    @bearkatljl Před 5 lety

    Umm is that really how you grease the front and rear u-joints? That looked like he was only greasing the shaft cover so that it could spin.

  • @markmiles4359
    @markmiles4359 Před měsícem

    Stay away from Rhino. Parts support is non existent.

    • @RhinoBornToLead
      @RhinoBornToLead  Před měsícem

      What parts are you looking for?

    • @markmiles4359
      @markmiles4359 Před měsícem

      @@RhinoBornToLead 00763624. I also needed a sheave which I found by a stroke of good luck on the dusty shelf of an old farm store in Iowa and 00769484 which, after much investigation, I found was the same as a Land Pride part which I got from Land Pride.