Chevy 12 Bolt Ring and Pinion Install Part 1
Vložit
- čas přidán 9. 05. 2018
- Installing the ring and pinion gears in a chevy 12 bolt. Setting the backlash from the ring and pinion and explaining the install. Next video to show the pinion install with the crush sleeve.
- Auta a dopravní prostředky
To press on the pinion bearing, if you flip over the pinion in the opposite direction you did it, you don't need the pipe. You'll be pressing directly on the pinion gear. Easy peasy. :)
Very instructive ,thank you. Question : changing 3:73 to 3;23 on my 10 bolt cover , is it ass. Easy gust to change gears. Or am I having to change Carrier. It’s a 79 Pontiac T/A. Thanks again.:)
👍
I came here because this video was a search result for "chevy bolt"... not quite the "Bolt" I was after, but interesting anyway. :-)
Haha not quite!
Right i though it was the rear end of that c10 and it looks like a car 12 bolt :(
Yeah it is a car 12 bolt. It went into my 66 impala!
ever used the solid with shims sleeve instead of the crush one ?
I’ve only used a crush sleeve before. Must be the cheaper option!
I have used those; they take a bit more setup time, but there is not chance of going to far and ruining your crush sleeve. I start with all of the shims, then keep removing them until I get close, then figure out if more or less shims are needed to get exactly the pinion preload you're after.
Looks like you have a hydraulic press but you don't have a bench Vice?
I have access to a press when I need it but I usually make do without a vice
@@iowadiy6361 that's tough when you need to secure something.
It leads to creative solutions for sure
hi men the rear end it a 8.875"?
Yes it is
@@iowadiy6361 tanks man
What brand ring and pinion did you use?
I went with Yukon. Never had any issues with it