Removing and Reusing Hydraulic Fittings
Vložit
- čas přidán 14. 02. 2024
- This is a way to remove hydraulic fittings off of a leaking or broken hose to re-crimp on a new one. Doing this is a temporary fix until you can get the correct fitting in or complete hose, however; I have many lines made using this method that are still being used, and none have failed.
You are making hard work of that. Yes cut on the flats to get deeper. Also a smaller diameter wheel helps. I make sure to cut as deep as possible without cutting the bit you want to keep. A nick on the hexagon doesn't matter. I never cut around. When you have both sides cut, Place it flat on an anvil, or some heavy steel. Take a small cold chisel place as near to the route end as possible and hit hard. They split quite easily, then turn over and repeat. Thanks for posting.
I was hoping you had some emergency repair Without using an expensive crimper machine .
i want to buy same crimper