DIY Raceway Installation | Ductless Mini Split
Vložit
- čas přidán 10. 05. 2020
- Installation of 3" raceway 'SpeediChannel' made by Diversitech. A critical step in installing the lineset for a ductless mini split heat pump. All parts purchased from SupplyHouse.com (see parts list below).
Parts List:
DiversiTech SpeediChannel: www.supplyhouse.com/DiversiTe...
Wall Sleeve 2 1/2": www.supplyhouse.com/DiversiTe...
Wall Penetration Cover: www.supplyhouse.com/DiversiTe...
Union Coupling: www.supplyhouse.com/DiversiTe...
Duct End: www.supplyhouse.com/DiversiTe...
90 Degree Long Radius Bend: www.supplyhouse.com/DiversiTe...
Plumb Bob: amzn.to/2yJnvsM
Step Bit: amzn.to/2WUFrIC - Jak na to + styl
looks great!
Very Clean job mate
Great job! Thanks for sharing!
Nice clean job!
Nice! Just the video I was looking for. I also ordered from supplyhouse but went with the fortress model.
Well done, well communicated. Thanks!
Glad it was helpful!
Super neat
Did you paint this to match your exterior?
What method did you find most effective for bending the line set 90 degrees at the wall exit/entry?
The indoor units have the stub-outs that extended a foot or two outside of the house. After connecting the lineset outside to the correct torque, I very slowly bent the copper tubes individually downward. I think I may have padded the hard edge and used one hand on the bend and the other a ways down for a bit of leverage. This is definitely one of the more nerve-racking parts of the install as a kink would require a new cut in the tube and possibly purchasing a new lineset depending on which step you're on!
Where’d you buy the lg split unit?
We purchased it and all the parts from SupplyHouse
You lost me at indoor condenser...
hey the system can heat too, right? :)