Linuxcnc Bare Bones, Part 4 - PNCCONF Wizard

In this video, I go over the basic settings needed to get started with LinuxCNC and Mesa hardware using the PNCCONF wizard by "da man" himself, Mr. Chris Morley, as well as a few little useful tricks that you may find useful with the 7i76e/ed boards.
Help support my coffee fund, if you feel generous :)
/ theferalengineer
Additional information regarding pncconf can be found here:
linuxcnc.org/docs/html/config/...
I apologize for the length of the video. I will post timestamps shortly.

[@andersmeiniche2746]

Have looked at this since it was called EMC2 and wanted it badly for all thees years.

[@clivesewart8723]

Thanks, Very good tutorial , keep up the good work.

[@pevlabs]

Thanks for the helpful guide.

[@ritusharma1092]

Really appreciate it !!!! Else linuxcnc does not have good video tutorials... and the 1000 n more page manuals are not directed towards end users. I'd love to see a video from you on qtDragon UI features and the workflow.

[@chrismorley5361]

I see a couple things in the homing discussion that are not so clear:

[@Sonar37]

Wow just subscribed very well done info.

[@odin823]

whats the difference between stepconf and pncconf? it seems like a lot of the same shit in two different config wizards that seem like they could all be in the same place. i mean they both create the same files right? or do they each create differnt files? maybe its just me, but it seems like they could both be in the same place right off the bat. great tutorials. i think ive seen just about everything you have done so far. a must for any linuxcnc newbie.

[@DPTech_workroom]

It's the 2.8 version?