PRISM SUPPLY | DIY Install | PS-41 Tail Light & Fender Mounting Bracket + Chop Your Sportster Fender

The vast majority of the parts we sell are specific to Harley-Davidson motorcycles. But, our tail lights and fender mounting brackets are universal!
So, whether you have a H-D Sporty or an enduro desert runner, these directions will show you how to install our PS-41 Tail Light and Fender Mounting Bracket. The instructions will also translate to any of our tail lights / brackets.
We also chop the fender on our shop Sportster, so pay attention to our trick for achieving a perfectly straight cut that looks like it could have come from the factory.
Make sure you’re subscribed to our CZcams channel so you don’t miss any of our videos and let us know in the comment section what part you’d like to see us install next.
Parts Used:
PS-41 Tail Light
prismmotorcycl...
Fender Mounting Bracket
prismmotorcycl...
Tools Needed:
- Safety Glasses
- Cut Off Wheel
- Sander
- Belt Sander
- Masking Tape
- Sharpie
- Small Phillips Head Screwdriver
- Standard Phillips Head Screwdriver
- Center Punch
- Power Drill
- Center Drill Bit
- ¼” Drill Bit
- Loctite
- 7/16” Wrench
- Wire Cutters
- Wire Strippers
- Lighter
- Heat Shrink
- Multimeter
- Digital Caliper
- Razorblade
Subscribe to Prism Supply on CZcams:
/ @prismsupply
Subscribe to our Newsletter:
manage.kmail-l...
Shop Prism Supply:
prismmotorcycl...
Follow Prism Supply:
Instagram: / prismsupply_
Facebook: / prismsupply
#prismsupply #DIY #tutorial #howto #install

[@colbybarron4300]

Absolutely a worth while purchase cleaned up the back end and only took an afternoon 🙌🏻

[@Roolis77]

You guys need a hot air fan for thermo covers 🤣... Love the stuff You do!!

[@pd1jdw630]

Would love to see how one would make a sportster into a small road king looking bagster with hard cases.
But this looks cool.

[@ilovecarnitas]

Tada! Cool vid. In case a viewer is wondering the license plate can be mounted below to the open holes.

[@ilovecarnitas]

hi guys. curious, do you know if the hole spacing on your bracket is same as those OEM bolt holes? have a paint job on it and hoping to not put new holes in.

[@remiallen6119]

Thanks for this!
Just ordered a brake light and plate bracket from you guys, I'm going to chop the fender just like that.
Is there a way to protect the fender from rust where it was cut? Besides doing a full paint job? Thanks!

[@PrismSupply]

Thanks for the support!
There are a number of options you can go with. You could do a simple clear coat or an even easier route and use a paint pen or something along those lines.
Hope that helps!

[@nathanphillipson1457]

Hey guys could you do a video detailing how to use the single wire tail light magic box? Cheers

[@PrismSupply]

We're planning to soon!

[@ralfrainfurth6034]

Cool

[@LarsGalbraith]

Should use deutsche plug

[@Akendic01]

Can't you just buy iron 883 fender and replace it instead of going through all this?

[@danahill3103]

What sissy bar is that??

[@Pvt._Liquor]

That bracket looks sloppy with the unused bolt holes hanging off the edge.

[@PrismSupply]

They won't be unused when there is a license plate attached to them.