Hey Bear! Glad to see you. I was going to tell you that I made some progress on the engine today. I measured my rod-to-crank journal clearances and they were all good (.002-.0025", even though one (# 8 cylinder) is a little loose for my liking (.003"). I also file fit all my rings. I set the top rings to .020" and the second rings to .020-.024". Tough to do in the heat today, but I think it was worth it to inch a little closer to getting this done. I hope you are doing alright. Have a good week if I don't hear from you sooner my friend. God Bless you and yours.
Hey Bear! Glad to see you. I was going to tell you that I made some progress on the engine today. I measured my rod-to-crank journal clearances and they were all good (.002-.0025", even though one (# 8 cylinder) is a little loose for my liking (.003"). I also file fit all my rings. I set the top rings to .020" and the second rings to .020-.024". Tough to do in the heat today, but I think it was worth it to inch a little closer to getting this done. I hope you are doing alright. Have a good week if I don't hear from you sooner my friend. God Bless you and yours.
Glad your getting motor together now.
I appreciate the update. Better luck next time. I might be heading to Iowa this month would be cool to link up. Take care. Glad your here buddy
That be cool
thanks for letting us know bear
Be safe my friend
I'm try
hope your doing good buddy
I'm trying to hang in there
Checking on you brother! Hope you and the momma bear are doing fine! Haven’t seen any videos as of lately! Again hope your doing good.
Hopefully about to be back to doing videos and Sunday show soon.
Hey, sorry. Will pray for ya!
Thanks
Take care , we will be here.
Thank you
Hey buddy are you doing all right lout of us I'm shere where you bin you have not put no new videos out hop your doing good
I'm still alive just to much going on off camera
Have a 377