Just as a quick side note when tackling this project, if you remove the top trim above the cup holders that runs under the shifter lights you can get access to the fuses easier. It's just held in by a couple clips so you can use a plastic trim tool to do so. Also ran into a problem with removing the console out itself with the shift knob in place and the easiest way to remedy that is by pulling up the boot and gaining access to a ring, located on the very top of the boot, pry the ring down and that allows you to remove that top portion of the shifter. I hope it helps anyone else on the project!
Besides buying it brand new from the dealer look on EBay. I just looked it up and found several used ones in great condition for around $50 / free shipping. Also, car-part.com is another great place to buy used parts. Hope this helps. Alley 55 Customs
I’m wanting to run a 4ga wire under the carpet for a sub and power inverter. This helped a lot. Thank you
Just as a quick side note when tackling this project, if you remove the top trim above the cup holders that runs under the shifter lights you can get access to the fuses easier. It's just held in by a couple clips so you can use a plastic trim tool to do so. Also ran into a problem with removing the console out itself with the shift knob in place and the easiest way to remedy that is by pulling up the boot and gaining access to a ring, located on the very top of the boot, pry the ring down and that allows you to remove that top portion of the shifter. I hope it helps anyone else on the project!
Our 2017 Renegade console side panels are different than shown here. There no small plug caps to remove. Looking for how to remove.
Does anyone know how to get the cup holder liner that’s in the video?
Besides buying it brand new from the dealer look on EBay. I just looked it up and found several used ones in great condition for around $50 / free shipping. Also, car-part.com is another great place to buy used parts. Hope this helps.
Alley 55 Customs
@@alley55customs93 Thank you!!
Is it possible to remove and replace only the USB/aux/12v piece?