POWER STEERING ISSUES IN VOLKSWAGEN , SKODA AND AUDI | FAULT CODES | OBDELEVEN
Vložit
- čas přidán 15. 01. 2023
- This video is about a power steering fault , or EPS fault , which will show up in multiple control units which are connected together , checked through OBDeleven
related faults codes - U140000 , B200FF0 , U111100 , U000100 , 01309
faults like function limitation due to missing message
canbus system issues
low voltage issues - Auta a dopravní prostředky
Please make a video on Airbag light also
Sir video please in hindi and please tata safari aur video bnao
How did you check your mobile for various car problems? Do you have any suggestions for Honda?
Hellos, I'm having a problem with my WV polo 1.2 tsi which I was changing suspetion. Then after the Cas steering is hard and have a red light of power steering on the dashboard... It talks about angle sensor when diagnosed...
Sir was the alignment done in the right manner ?
Yes, I took it to 3D alignment
Can you tell me the exact code you are getting sir ? Because i want to know , whether the angle sensor is reading wrong angle or it's not working .
P160900
B201000
U042800
Here are the codes
My vento tdi does increase its rpm under load sometimes and upon checking the voltage it's around 14.7 on idling and 14.0-14.2 under load.
Is it normal?
Perfectly fine
This is how troubleshooting is done! Instead of disconnecting the MFD, can we disconnect the battery to reset the modules?
Sir yes it can be done , but battery needs to be disconnected for at least 15-20 mins , because almost all modules have capacitors and they can store a little bit of energy for some time , so we need to wait until those caps are drained
@@yourDIYneeds thanks
Thank you for this info. Which app are you scanning with?
Sir OBDeleven device and their app
Bro swift diesel 2014 ke liye castrol 15w 40 engine oil kaisa rahega?
Sir 5w40
@@yourDIYneeds castrol or shell?
Sir shell
My garage guy insisted me to put 0w30 fully synthetic engine oil in my 2015 vento Diesel is it good oil
Sir have a look at this video - czcams.com/video/X-sN9lZc7y8/video.html
bhai ap apni video England mai ja ke bnaye. Q k yahaa jiyada log Hindi samjhte hai. agar ap genuinely kisi ki help karna chahte ho to language ka dhiyan rakhe. thnx
Bhai g hum Diesel swift mai shell 10w40 engine oil bhi use kar sakte hai kya?
Hanji sir bilkul
@@yourDIYneeds thanks bro bhai...
You tube pai bus apke he channel pai reply aata hai.thanks bro keep it up
Hi. I get an error under Central Electronics like:
01598 - Drive Battery Voltage
000 - -
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 1
Reset counter: 27
Mileage: 164624 km
Time Indication: 0
Date: 2017.08.12
Time: 06:37:45
I tried clearing it, but the error came back again. Sometimes the car idles a bit high (1000 rpm instead of 900 rpm) and the radiator fan spins at full speed. Numerous forums tell it’s a faulty alternator or battery. Just few months back, I got my battery changed. The voltage hovers around 13.5. Check after overnight, the voltage was at 12.7. Any idea what issue it might be?
Sir , can you tell me which vehicle you exactly have , because a lot of vehicles may require you to code the new battery as per the specs of the new battery , so that the alternator can adjust itself for charging
@@yourDIYneeds Thanks for the reply. It’s a 2012 1.6 TDI Vento. Does PQ25 platform require battery coding like MQB?
No sir, PQ series of BCMs doesn't require battery adaptation, alternator has a specific part called " voltage regulators" which can go bad , but that doesn't make the voltage reading "000" , it will start to throw out either massive amounts of voltage or no voltage at all .
If there is no issues with the engine cranking , and alternator is doing its job of charging the battery and powering the electronics , then it can't be alternator .
What i feel like is , its more of a fault with the voltage reading circuit of the BCM itself , because at the end of the day , both ECM and BCM are nothing but just very advance Multimeter which has the capabilities to send and receive signals multiple times per second . If voltage is low then it will throw a code but that's not the situation here i guess. So either the transmission end of the stream is bad or the receiver end , in both of the case we will get the same code .
Hope i made a valid point to understand .
@@yourDIYneeds Thank you so much for the input. I’ll test it out and let you know of the results.
@@yourDIYneeds Hi, I took out the negative terminal off the battery for about 5 mins and put it back on. Cleared the error code and it didn’t come back. Thanks a lot.
One more query. Is it bad for Camshaft position sensor to be higher than 4.8 degrees? I got timing belt replaced earlier and still the values sits at 5.25 in warm conditions. Could it be a bad sensor or timing needs to be rechecked?
Hello there, i want to get Punch remapped, will it be safe? Watched your video
Sir , it will be safe but not that reliable
@@yourDIYneeds will something happen to the engine? I just want to get rid of the lag and improve driveability that's it, no high end remaps
It will improve driveability, can't say anything about the lag , because it depends upon engine to engine
Hello, i have a audi a3 2004 it is saying sometimes that it don't have communications with the steering module incheckt the wire and fusses.. some times it works. Does the steering module is going bad.? Or can it be the steering sensor.?
First is to make sure that the steering module is getting proper voltage ,
Check continuity for grounds , as half of communication faults are just because of drop in voltage .
And check the electrical connector of the steering module for any corrosion buildup
@@yourDIYneeds i have checked the wires expect on the steering house because it is hard to get there. Is the module at this type at the steering wheel?
Then try scanning the module and check the resistance and power voltage on the module from the diagnostic tool .
@@yourDIYneeds i wil try i have now autel my vcds it not working. And do you know where the module is?
Module no. 44
Go in live data and check the parameters
sir any body repairing powersteering modules
Sir , it won't get successful
Safari dicor pr video banao
13-46 to 13-56 after start the car., You changed the polarity + & - 😆😆
Sir i was basically testing voltage and continuity
In continuity polarity doesn't matter
In Voltage it does but it shows reading in -ve
And i was sure that alternator is producing power not drawing it 😅😅
The MID of my polo is getting dimmer from the right hand side the intensity of the MID light is lower from right side...How to fix it?
Sir , screen replacement can be done but finding the right screen will be a task
Brother there is no video on Tata safari, did you sell your vehicle or any issue with vehicle?
Sir i gave it to my cousin, as we can not drive any diesel vehicles which are 10 yrs old in national capital
@@yourDIYneeds OK bro,, but missing d beast,, u know what it feels 🙌
Yes sir
Difference between VW 505 00 and VW 505 01... Will they make any difference?
Yes sir approvals are formed on the basis of presence of specific additives, they make a lot of difference in longevity of the engine
Bro , can you share the link for vcds hex cable ?
Sir you check their official website and check for price and do let me know the price , because i have a person who is into these things , then afterwards i ll confirm from him , whichever will be less expensive , you can buy from that source
Sir my safari dicor 2.2 model is having starting trouble .... He is not starting in first self after 5 min of rest he start but service light is continuously started when engine is ON
Have you checked glow plugs ?
@@yourDIYneeds no I have not check but is that only the issues or other one because after the engine start car not automatically off but when we off the engine and then trry to start it's not starting and after same time it's started so glow plugs is the issues????
Sir had car ever ran without fuel , air got into the fuel system ?
@@yourDIYneeds yes... Not run but trying to start
Sir may have to check the pressure of high pressure fuel pump
Where do you get the security code for coding ?
Sir they are available in obdeleven platform and if they are not then you can search for it
Tata safari drag race
Which app is this ?
Obdeleven
15.8 volts at idle is a faulty generator.
I just charged my battery up and the fault light was gone. New battery would also s=resolve this issue.
Yes , voltage issues can create the issue
Hello, How are you and how to contact you??
Sir i am doing good , hope you are also doing well, you can contact me on my mail everydaydiyhelp@gmail.com
What’s the cost of OBDeleven n from where you bought? I have VCDS HEX-NET right now
Sir if you are using Android then its for €40
If apple then €60
Have you sold you Safari? 😰
Sir gave it to my cousin , as it was 10 yrs old now and we can't drive a vehicle which is 10 yrs old in national capital
@@yourDIYneeds hope you meet your cousin soon and make some videos❤..
Your safari's videos were stress-buster😅
😂
Can use the same fix for golf 7?
Yes procedure is exactly the same
@@yourDIYneeds thanks boss, I'll go try now. I have same issues. Red steering. But sometimes its fine... Sometimes it makes this problem.
Unfortunately on my golf that did not resolve the issue. The red steering light still comes up
Tried disconnecting the cluster ?
@@yourDIYneeds yes... I disconnected the cluster.... And connect it back after 5 minutes. Didn't work, now left it disconnected and batteries are disconnected too now .. i will connect it in the morning and see how. Is there other fix for this?