Scotts Classic 20 Inch Mower Blade Sharpening Kit demonstration procedure
Vložit
- čas přidán 22. 07. 2024
- This is a procedure that I demonstrate for sharpening the 5 blades of a reel type push mower. I have the Scotts Classic 20 inch push mower and it is now cutting excellent. I also demonstrate Proper way to adjust the Reel culling blades to the cutting bar.
Click on link below to view on Amazon for ordering.
www.amazon.com/dp/B00004R9UM/...
Commission earned
Chapter Segments
00:00 Intro
01:51 Open Product show what you get
02:10 Show sharpening compound
02:42 Demonstrate position for mower
03:12 Check Cutting Bar to Blade Adjustment
04:40 Show Adjustments for Cutting Bar
06:23 Start following User Manual instructions for sharpening blades
07:33 Remove Right Wheel
08:24 Remove Drive gear
09:04 Show use of blade turning handle
09:54 Apply compound to all blades cutting edge
10:41 Demonstrate turning handle for blade sharpening procedure
11:01 Inspect blade cutting edge for results
12:17 Important infor about position of Blade Pawl if falls out when handle removed
14:30 Installing wheel and finishing up with mower. - Jak na to + styl
Sam Owens, this is a super-helpful video! Thanks!
Thanks Sam, I just used mine to cut my grass the second time and I love it. Get yourself some of the Big Blast WD-40 for lubricating before and after you cut the grass.
Yes, I spray lube on the cutting bar and blades. Cuts much nicer.
Thank you sir
I just got the same one brand new, Doesn't cut paper on the sides only middle, should I tighten a hair on Both sides or is the whole thing defective? I called the company before ordering and they told me it would be calibrated new.
I got it to cut on both ends, trick was to adjust both sides simultaneously
@@brianbaldino3496 Yes,, you have to see where it is cutting good and where not, if just on one side, you can adjust very small amount to bring into cutting condition. A few times and you will develop the technique that meets your requirements. Good luck. Use a lubricant on the blades before cutting, spray clean the mower after cutting and spay WD-40 all over to displace all the water. Will last a very long time.
@@samowens44 I've been using the 16 inch model for a season, always wiped down the blades with WD40 After cutting. Supposed to do in before cutting too?
@@brianbaldino3496yes, lube blade and cutting bar with WD-40 before cutting and it will cut best.