Headlight Restoration Menzerna 400 Compound & 3500 Polish and Sonax Profiline Headlight Coating

Headlight Restoration Menzerna 400 Compound & 3500 Polish and Sonax Profiline Headlight Coating
Here I show what steps I take to get the headlights looking like new again. I also immediately protect them with a very good Coating from Sonax Profiline with up to 1 year of protection.
Subscribe to waxkingcardetailing Here / @waxkingcardetailing
waxkingcardetailing on Social Media
Website waxkingcardeta...
Instagram / waxkingcardetailing

[@juanestebanestigarribia.2770]

Do you recommend putting a ppf or is this coating enough to protect from UV rays and scratches? thanks for the reply 🙏

[@waxkingcardetailing]

Hello, No, with this Sonax Headlight Profiline you are good for a year, if you had not done PPF. It is resistant to UV but not scratches even if you have a coating.

[@Alcoholicpogson]

I think I would’ve used a ceramic coating like Gyeon MOHS because it shines and wiped off easier. It almost looks like the headlight coating dulled the polish you just did prior. Or a paste sealant that you could leave on for some minutes to bond. But you’re an exit so maybe it looks better after some self leveling 14:47

[@cmongimme]

Nope, cover with quality ppf! 👌

[@waxkingcardetailing]

Yes the headlight just became super bright at the end. It's easy that this coating is in a bag is just right for 2 headlights.

[@americantruckeringermany8394]

@@waxkingcardetailing too bad you did not show the end

[@gastongallo3913]

I like when it is clearcoated, than it last. If you just polish plexiglass, you have to take extra care of it, so not for me.. I want as less maintenance as possible so I better spend 1 hour more but result is much durable...

[@americantruckeringermany8394]

so confused. why didnt you show the final result after curing. what rpm are you running the machine at?

[@waxkingcardetailing]

The end result is actually the photo. R.P.M. is for this machine between 4000-5500. I had it here on position 2. Normally I have it on position 3 or 4 for polishing.

[@cmongimme]

Hands down best headlight restoration video! And I already have most of that stuff, what speed did you use on your Rupes 3"?? Thanks dan

[@waxkingcardetailing]

Thanks sir, Here I have the machine on position 2, this went perfectly for the headlights. Usually on paint I use the machines setting 2 to spread compound or polish. And then I put it on setting 3 or 4 to polish.