Thanks for the video. You should set your torque wrench to 50 percent the first torque, and 100 percent, the final torque. You never achieved your proper torque by your short stop, near final torque. 😊🇨🇦
You only Isol flex the outer mag / PTO bearing. The inner mag and PTO bearings are sealed as well as the two red sealed Center bearings. Weird I know but that’s directly from the BRP factory manual
the center bearings are bathed in 2 cycle oil. but you should install the y pipe exhaust before you torque down the jugs it will help with alignment
monoblock. gonna be the same no matter if you put it in before or after 😐😑😐
This content just keeps getting better!!!!
Thanks for the video. You should set your torque wrench to 50 percent the first torque, and 100 percent, the final torque. You never achieved your proper torque by your short stop, near final torque. 😊🇨🇦
We’re back baby!!!!!
if that is hi temp rtv i wouldn't use that for crank halves.. its not oil and gas resistant, I use motoseal.
Oo man I own 08 800r I am buying a 15 renegade 800 xrs 137
How do you remove the water pump from the block?
Did you put Isoflex in the center bearings also?
You only Isol flex the outer mag / PTO bearing. The inner mag and PTO bearings are sealed as well as the two red sealed Center bearings.
Weird I know but that’s directly from the BRP factory manual