Rear wiper arm repair 2003-2009 Toyota 4Runner 4th Generation seized spline
Vložit
- čas přidán 12. 09. 2024
- Remove the broken wiper and heat the press ring to remove. Install the new arm and blade and cut to adjust tension
4:11 heat with torch
4:58 removal of seized spline collar
8:10 installing arm
11:53 cutting arm to increased tension
13:50 testing with washer fluid
Amazon part link below
OTUAYAUTO 8524135031 Rear Wiper Arm Blade Set, Replacement for Toyota 4Runner 2003-2009 a.co/d/d9Fgd7o
Dude amazing ... I was dreading this project on my 2004 4runner because the "nut" was rusted on tight. Most folks were saying..."lube and tap, lube and tap". I did that till I was frustrated and came to your video. BAM! HEAT! took me 3 minutes and the damn thing pulled right off. Thanks Jacob! This is what makes CZcams and folks like you wonderful! Cheers!
Thank you for the positive feedback. CZcams has helped me through so many obstacles too
Thank you!
Thank you for upload this video.
I got the same problem with the arm stuck into it, unfortunately I don't have a torch. I don't know what else to do
Try a blow dryer on low speed high heat. It may be enough if you hold it there longer. Also try penetrating oil, only a small amount each day for a few days to see if it lessens up. I believe the wiper is brass and a softer metal so it may just take more time without a torch.
Thanks, how is it holding up so far?
It is still working great!