2005-2006 ZX636/ZX6R NO START (FIXED)
Vložit
- čas přidán 27. 09. 2023
- The bike is flashing a fuel light and will not start. Basically the problem came down to the fuel pump not being grounded. Which created an issue within the actual pump too. This made it so that the bike would only run with the tank up. If I put it down, it would die. So I figured out, it's actually from the fuel tank not grounding (which didn't ground the pump as well).
- Auta a dopravní prostředky
Thank you for mentioning the it only primed when the tank was tilted, i had the same exact issue and it was stumped. You confirmed the ground issue is what i really need. I depinned the original connectors ground wire on the harness side and ran a new wire straight to the battery negative and she was good as new . And you can remove the tank without any extra steps too
I'm glad you got it fixed and taken care of! I was going to go ahead and go into the harness, but the customer just wanted a switch instead. You could solder a wire from the tank to the frame as well if you wanted to.
Where are you located?
What if the fuel pump doesn't stop priming?
Sounds like you have it on the wrong connector, or… Something may be shorting.
Wish you would have shown what it sounded like and was doing before you fixed it
There was no fuel pump prime before fixing it. Absolutely no fuel pump prime when key was turned.
I mean he stated the exact problem in the beginning lol fuel pump wouldnt prime unless the tank was lifted.. this is when you have gone through every other test is when you should be watching this.
Does it stay running when u flip switch?
Yes it does. The switch is to turn the pump on, so whenever the switch is activated, the pump runs.
@@twowheelthings did or do u know if customers bike ran fine? I have the same kinda issues.
My pump works but when I connect it to ground harness I have no power
@@patrickyell3769 after using the switch, it ran perfectly after. It basically wasn't grounding the tank, which would then not give the fuel pump power.
@@twowheelthings last thing
So with switch on it did it prime for a few sec then stop like normal or continuous.
@@patrickyell3769 with the switch, there's no priming. It just runs it continuously. If you're trying to fix it without that, do what I did with the wire that grounds it and solder it. It'll be better than having to flip a switch and having it run no matter what.