If the bobbin case has been installed correctly, that's probably the thread clearance for the bobbin case need to be readjusted. The upper thread needs to go through smoothly on the bobbin case area.
@@catsam1429 If I keep the slide plate open and sew, it works. If I close the slide plate, top thread is going inside the bobbin area and getting tangled.... As far as I understand, thread clearance to the bobbin case is provided...
If that's the presser bar problem, the presser bar height need to readjusting; if only some thick fabric can't feed through, you just need a even feeding foot.
@@francescaxo2350 First take off the face cover, look for the screw that holds the presser bar, make the needle to the lowest position by turn the hand wheel toward you, lower the presser foot, loose that screw and then tighten it. In order to access that screw, you may need to take the head shield off too.
Merci beaucoup
i just got one of these at a goodwill, it was missing the foot pedal so i ordered one i hope everything goes smoothly 👌😁
i had been doing really good everything was going smoothly but now for some reason it’ll sew fine for a couple seconds and then slow down and stop
Dear i want to ask you something
I recently got 9123 machine. Top thread is getting tangled in bobbin case and unable to sew straight stitch. Can you please help?
If the bobbin case has been installed correctly, that's probably the thread clearance for the bobbin case need to be readjusted. The upper thread needs to go through smoothly on the bobbin case area.
@@catsam1429 If I keep the slide plate open and sew, it works. If I close the slide plate, top thread is going inside the bobbin area and getting tangled....
As far as I understand, thread clearance to the bobbin case is provided...
My bobin keeps getting tangled. Cant sew anything. Even replaced the bobun holder.
We're you able to fix the problem? I am also facing same issue, top thread is tangling around the bobbin case
Is this machine loud when sewing? Thanks
Kind of normal mechanical sewing machine sound.
Hi! Would you happen to know how to change the presser foot tension on this machine? Mine is so tight and doesn't feed the fabric through? Thanks!
If that's the presser bar problem, the presser bar height need to readjusting; if only some thick fabric can't feed through, you just need a even feeding foot.
@@catsam1429 thanks for answering, would you happen to know how to readjust it?
@@francescaxo2350 First take off the face cover, look for the screw that holds the presser bar, make the needle to the lowest position by turn the hand wheel toward you, lower the presser foot, loose that screw and then tighten it. In order to access that screw, you may need to take the head shield off too.
Thank you so much!
我的9 113衣車不知什麽原因,所有的pattern車出來都直線,所有的掣都按齊。
我會檢查针迹寬度控制
Kill the music or lower it down so the machine can be heard.