MS08b. [Stepper Motor] 1/2 Siemens S7-1200 PLC PTO Stepper Motor Control (Technology Object in TIA)

#steppermotor #tiaportal #s71200
Next: Motion Control Programming for Stepper Motor • MS08c. [Stepper Motor]...
Key Words: Stepper Motor; Siemens S7-1200 PLC; PTO; TIA Portal; Technology Object
This video introduces how to use Technology Object in the TIA Portal and Siemens S7-1200 PLC PTO to control the stepper motor.
I appreciate you could buy me a coffee via the PayPal link below:
www.paypal.com/donate?hosted_...
Siemens Control Playlist: • Siemens Controls
Motion Control Playlist: • Motion Control
[DC Motor]
MS04a. Setup Positioning Axis via Analog Output, DC Motor, and Encoder
• MS04a. [DC Motor Posit...
MS04b. Program DC Motor Positioning Control via S7-1200 and TIA Portal
• MS04b. [DC Motor Posit...
[Stepper Motor]
MS08a. Stepper Driver Wring with PLC 24v Pulse Signal (TB6600 FMD2740C)
• MS08a. [Stepper Motor]...
MS08b. 1/2 Control Stepper Motor with a Siemens S7-1200 PLC - Technology Object
• MS08b. [Stepper Motor]...
MS08c. 2/2 Control Stepper Motor with a Siemens S7-1200 PLC - Motion Control Programming
• MS08c. [Stepper Motor]...

[@maulanawahyudi7127]

Very detail, good information. Thankkkk youuu !!!!

[@electricalautomation]

Glad it was helpful! Welcome!

[@andregoncalvesee]

Very very good. well explained. Thank you.

[@electricalautomation]

Welcome!

[@tarikrachiahi1239]

Thanks for this great video

[@electricalautomation]

Glad you liked it!

[@aliriza6834]

great explanation 👋👋

[@electricalautomation]

Many Thanks!

[@MultiRider59]

крутой гайд! спасибо!

[@electricalautomation]

Thanks Man

[@matthewgiannotti3355]

Fantastic video, thank you. Is it possible to control multiple 5-phase stepper motors with their respective drivers from a S7-1200 DC/DC/Rly, so in other words, with relay output from the S7-1200?

[@electricalautomation]

using Rly can not output the PTO high frequent pulses. But you can buy a " SB " board, then use this SB board to output pulses

[@jeroenverhoeven6904]

Is it possible to use a encoder handwheel like on cnc machine. To drive the servo manualy. Could you make a video if this topic. Greetings from Holland.
Ps i like your video's they are very clear and easy to understand.

[@electricalautomation]

you could view this application about handwheel function with Siemens T-CPU support.industry.siemens.com/cs/document/109807355/handwheel-function-with-simatic-s7-1500(t)-controllers?dti=0&lc=en-US