Nissan r51 parthfinder d40 navara and Frontier fitting an egr block off kit

how's it going push roders this video im fitting up an egr block off kit to our r51 pathfinder from yd25.com.au kick back relax and ill do all the spannering/ wrenching and as always thanks for watching🍻👍🇦🇺

[@matthewjames4977]

Gday, where did you source your delete kit from?
My 2010 D40 is having EGR issues.
Cheers.

[@pushrodtv6623]

I got the delete kit from yd25.com.au scroll down to products it'll be in there hope this helps you out and thanks for watching 👍🍻

[@stevesutton6093]

I would look at a catch can before swapping out the TC as normally if the shaft seals go the compressor side is the higher pressure so the oil tends to go out the turbine side and into the exhaust stream. This is usually quite visible to all and sundry so I would imagine you would have either noticed it or been advised by the other drivers dealing with the smoke screen! 😂 I would also recommend giving the intercooler a clean as it is probably full of oil as well.

[@pushrodtv6623]

Theres no real smoke screen i think it need a catch can which is on the to do list as well as giving the intercooler and piping a good clean out thanks for watching and commenting 👍🍻

[@DunkenMyDonuts]

I’ve been looking at EGR deletes, I’ve heard one of the reasons to avoid it is to prevent knocking or the exhaust overheating. Have either of those issues occurred for you?

[@pushrodtv6623]

Ive had no issues ,exhaust gas / egt's/ over heating would be becuase of over fueling and being diesel they knock carry on because thats what diesels do unless its got bad mechanical problems thanks for watching 👍🍻

[@user-vn7fk1te6u]

If these no EGR valve on D40 what to block of

[@pushrodtv6623]

If your D40 has no egr then you dont need to do anything thanks for watching 👍🍻

[@13965082]

Manual only? Because I believe autos have dpf installed

[@pushrodtv6623]

Thanks for watching 👍🍻

[@hexxe]

After EGR block what change on car ?

[@pushrodtv6623]

Not overly to much a little bit more fuel economany , a few kg's of whight savings and buy removing the pipe that goses from exhuast to intake manifolds that has coolant running through it is one less posable place for coolant to leak thanks for watching 👍🍻

[@user-sv3uy2ol8u]

Does it seem more responsive with it removed? What about the restrictions plates with 10mm hole or whatever? I'm wondering if this will help, mine seems bit unresponsive trying to rev when letting clutch off, drives fine though, just taking off in 1st