Thanks for the great explanation ,for the first time someone who making video about mtu engines on tube . i just want to know on which command basic the recirculation valve (UMBLASEN) open /close and when? (exactly how much pressure on intake it will give command )
Below 1700 RPM if both turbo charger will run then both will run at low RPM which results in less cjarge air pressure ...it is due to less exhaust pressure
thanks for the video, i have a question on the Air intake flap, when we increase the engine RMP around 1700 rpm, the turbo does not come on, I was wondering while increase the engine I manually open the flap???is it ok?
Sir ji pura pura smjh me aa gya
Mukesh monster! Congrats for presentation.
Great video. Thank you for this!
Very very Good video thank you so much Mukesh!
Thanks for the great explanation ,for the first time someone who making video about mtu engines on tube .
i just want to know on which command basic the recirculation valve (UMBLASEN) open /close and when? (exactly how much pressure on intake it will give command )
Mtu 2000 series plz make video
Super sir thank you
Please how to know if our 4000 mtu has sequencing system
What is problem due to engine turbo charger shaft is dreak to the compressor side
sir kindly please upload video mtu 12V400G23R engine
Good morning, how can I disassemble the water pump of the MTU 12V 4000 engine. Can you help me?
Good day sir , what happens if the recirculating valve does not open ?
My 12v 4000 will no longer run up pass 1600 rpm and the etc two does not cut in
Indonesian translation, thank you
why does 38 alarm come out at idle?
Thanks for the video, I just want to know why ETC 2 is closed during idle speed or below 1700rpm?
Below 1700 RPM if both turbo charger will run then both will run at low RPM which results in less cjarge air pressure ...it is due to less exhaust pressure
Hi Mr.Mukesh, its a great video explanation. How about MTU 2000 series? What is the approximate engine RPM to activate the ETC2?
thanks for the video, i have a question on the Air intake flap, when we increase the engine RMP around 1700 rpm, the turbo does not come on, I was wondering while increase the engine I manually open the flap???is it ok?
There may be a problem with 3/2way solenoid valve which operates ETC 2. Opening manually also ok.
Hi Mukesh
How you know about this engine
What to do if ETC 2 isn't cutting in?
Check the linkages associated with ETC Flap actuator. They should be free when engine is in static mode.
Sir please let me 3 condition start time after 2 condition
Sir security showdown my engine ,help me