EasyThreed X1 Mini Hardware & Software Setup
Vložit
- čas přidán 7. 04. 2023
- In this informative video, we will guide you through the process of setting up the EasyThreed X1 Mini 3D printer. Whether you're a seasoned 3D printing enthusiast or a beginner just getting started, this video will provide you with a step-by-step tutorial on how to set up your hardware and software with ease.
We will cover everything from unboxing the printer to assembling it, as well as how to install the necessary software on your computer. Our tutorial is easy to follow, with clear instructions and helpful tips along the way.
By the end of this video, you'll have a fully functional EasyThreed X1 Mini 3D printer and be ready to start printing your own designs. So sit back, relax, and let's get started!
The EasyThreed X1 Mini can be purchased here:
leobot.net/viewproduct.aspx?i...
Check out leobot.net for my shop. - Věda a technologie
The ultimaker curi 5.3.1 was on the flash drive but after putting onto laptop and loading it a message came up to say a piece was missing I un installed it then tried again but this time it wasn’t on the flash drive
If you want, I can share the software from the flashdrive on the leobot website.
Also, it may be that your anti-virus picked it up and deleted it from the flashdisk (I have had that happen before with Chinese installers with other systems but not this one).
Also, luckily, you can download Cura easily from the internet and do not need the version they provided on the flashdisk.
Omg LEEOO my man
I have a google computer and I can’t understand how to make anything other than the rocket. I am genuinely confused and don’t understand can you make an easier video please 🙏
Hi, there are a couple of ways to make models. (With Fusion360 or Blender)
Also, you can download existing models from sites like www.thingaverse.com.
I can make a video dedicated to this, sure, but I guess you are in a bit of a hurry and it might take me some time to do. -If you are in the PTA area you are welcome to come to our shop for me to assist.
No hurry I can wait for the video. Also where is the PTA area?
Also will those websites work for the K7 also? That is the Printer I have
My rocket fails every time the pka won't stick
Apply a light layer of Pritt glue to the bed before printing; that should do the trick (even with my expensive printers this happens). Just DONT use permanent or super glue though!
www.prittworld.co.za/en/products/glue/glue-sticks/original-pritt-glue-stick.html
Do you think I can do this 😂
Waar daar n wil is is daar n weg ;)
yes