Amazing Works Jaw Crusher Machine Bearings Replacement || How To Replace Bearings

Amazing Works Jaw Crusher Machine Bearings Replacement
Preparation
1. Gather necessary tools and materials:
- New bearings
- Bearing puller
- Socket set
- Wrench set
- Grease
- Safety glasses
- Gloves
2. Ensure the jaw crusher is properly shut down and locked out.
3. Remove any protective covers or guards to access the bearings.
Removal of Old Bearings
1. Locate the bearings to be replaced (typically marked with an arrow or label).
2. Use a bearing puller to remove the old bearings. If stuck, apply heat or penetrating oil.
3. Remove any remaining bearing fragments or debris.
Installation of New Bearings
1. Inspect the new bearings for damage or defects.
2. Apply a thin layer of grease to the bearing seat and surrounding area.
3. Install the new bearings, ensuring proper alignment and seating.
4. Use a socket or wrench to secure the bearings in place.
Reassembly and Testing
1. Reinstall any removed components or guards.
2. Lubricate all moving parts, including the new bearings.
3. Perform a test run to ensure proper operation and no unusual noises or vibrations.
Remember to prioritize safety and follow proper procedures when performing maintenance tasks like bearing replacement. If unsure, consult a professional or the manufacturer's support team.
‪@DiscoveringSkills‬
‪@pakistanitruck‬
‪@pkrestoration1461‬
‪@recoveryzone945‬
‪@AwesomeRestorations‬
‪@restorationking4085‬
#amazing #restoration #how #howto #repairing #hammer

[@PeterWilliams-pi9oi]

I note that every safety precaution was taken including gloves eye protection and safety boots etc

[@donalfinn4205]

Yawn.

[@leonardryan8723]

Your good for another million ton of stone . Tinken bearings way to go from Germany 🇩🇪 😊

[@user-cq2ov7kb9f]

прямо как в СССР: при помощи молотка ,зубила и какой то мататери.

[@antongyrt4814]

16:31 😂 Чем это он заслужил?

[@r.h.a.888]

16:31 "Батин" чапалах!

[@bikerkawa]

Почему подшипник не нагревали перед установкой? И почему он не закрыт сальниками??

[@shubbakikuti2322]

0.50 parece cenário da família dinossauro !!!

[@frankroy9423]

Looks like they didn't greast those bearings after they installed the crusher. Not even as a daily maintenance procedure.

[@roman-rv2rl]

16:31 за что?😂😂😂

[@jth1987leb]

Why did he hit him when they were putting on the bearing?

[@concreteblockmakingmachine]

because they are so cruel. that bearing is half gone already.

[@concreteblockmakingmachine]

hitting that bearing with a hammer like that damages the bearing. not a professional job at all.

[@user-ew9df8wm3m]

Не удевительно что он потом рассыпаеца вам ужин пресс

[@ershvv7567]

16:32 а чего нетак? По бошке получил за что?

[@pfauniversal1890]

We think it might be more about bollox than real life.

[@MrNodrog64]

Stupid crane driver receiving up on the wire 5command , yet he's jibbing up ??? Angle grinder would of had the inner bearing shell off in no time. Did that co worker slap the other worker on the head @16:34

[@phymil5489]

nobb...🤣🤣