XR15 REMOTE DEFAULT & PROGRAM

Rf Program to Receiver
Info and Menu same time, until green lights flashes and gives you 3 digit code on tv
For TV:
1. Hold A+D buttons until the light turns green.
2. Press 991
3. Keep hitting the CH up until TV turns off.
4. When TV turns off, push the center select button in the middle of the direction arrows.

For audio device:
1. Hold A+D buttons until the light turns green.
2. Press 992
3. Keep hitting the CH up until TV turns off. (it may take some time to find the code)
4. When audio device turns off, push the center select button in the middle of the direction arrows.
To set remote back to factory default:
1. Hold A+D buttons until the light turns green. Enter following codes. Green Light will flash when accepting code
2. Press 981 ( factory reset all)
3. 987 (receiver only)
4. 986 (tv/ audio reset only)

[@quincyx9372]

So glad I found you channel been at this for over a hour watching videos. You were the only one with other codes besides 981. Thanks.

[@user-zt4sv2bd3g]

Looked up and watched 4 other videos I only needed yours thank u!! Easy and fast!! 😊

[@tiaunnaconnelly5593]

Thank you this truly works my parents remote went out and we had to reprogram everything and it worked!! Thank you

[@lamarhamp1on]

The best one on here

[@mikeinvegas1]

Thank u. It worked. Best video on this.

[@user-kk3id1tn9h]

Thanks super helpful working now !!!!!!

[@johnmercurio3362]

I was so frustrated, but this video made it so easy. I was done setting my remote up in less than a minute. Thanks!

[@triciasoblessed5282]

Very helpful. Thank you very much.

[@user-kk3id1tn9h]

Thank you, very helpful

[@maliaarnold8293]

Thank you cause this worked!!!

[@phantommp5]

Thanks! It worked!

[@sjlouvieify]

Thank you! 👍

[@zzzenchantedxx]

Did not work

[@nicolecherrio9128]

How do you get the voice command to work?

[@sheilaroberts8326]

My remote is blinking blue, What do I do?

[@mrtogoodc]

What if u have no receiver

[@matthewtuccio4705]

No 3 digit code came up

[@christopherengland654]

Did you try holding down the "info button" and the "Contour" at the same time (while pointing the remote towards the TV? If not, hold it until it turns green then the 3 digit code should pop up on your TV, enter it with the COX remote and you're good to go 👍

[@indiahamilton2942]

Do you know if I can pair my contour remote to my samsung soundbar. I want to be able to use one remote to control all Audio (tv and soundbar). I’m wondering if I have to switch from optical to HDMI to do this.