Good swing out set-up. But is there any chance you could do a bit more of a review on the shower tent, showing how the roof attaches, how it opens (i gather its from the front, not side like other shower tents. Just an all over closer look would be very much appreciated. Cheers 👍
Excellent solution @scottyzbuildz ... just wondering if you could share the aluminium section, bearing and pipe / alloy stem sizes you used? Cheers man! Keep up the great work!
Thank you so much. Sure thing, the headset I used was 44mm bike stem, but I bought 2 and used both the bottom bearing and bearing seat. The main outer body was 100 mm outside Dia. And around 94mm inner. The swing out body was 80mm box, and the headset sleeve was cut to suit the required length for a tight fit. The tube was 44mm inner but did have a slight wiggle room, so I advise to paint the inter tube for a more snug fit. I hope this helps, and if you need more info, just let me know 😊
The whole point is that it swings away from the rooftop tent and allows the tent to open while having the shower tent alongside the tent. Also, it gets it away from the side of the camper. For my setup, it works great, and many people are even using them on their cars as it swings out from their canopy.
Excellent!!!!
Cool mancave!✔️✔️✔️
Thank you. It's very messy, though, haha. I have cleaned it up since
👏👏👏
@HardKorr Campers....check this out. Nice work mate
Thanks Timmy.. appreciate it 🙏
Good swing out set-up. But is there any chance you could do a bit more of a review on the shower tent, showing how the roof attaches, how it opens (i gather its from the front, not side like other shower tents. Just an all over closer look would be very much appreciated. Cheers 👍
Thank you. No problem, I will try to put a review video out soon.
@@ScottyzBuildz Thank you 💪
Excellent solution @scottyzbuildz ... just wondering if you could share the aluminium section, bearing and pipe / alloy stem sizes you used? Cheers man! Keep up the great work!
Thank you so much. Sure thing, the headset I used was 44mm bike stem, but I bought 2 and used both the bottom bearing and bearing seat. The main outer body was 100 mm outside Dia. And around 94mm inner. The swing out body was 80mm box, and the headset sleeve was cut to suit the required length for a tight fit. The tube was 44mm inner but did have a slight wiggle room, so I advise to paint the inter tube for a more snug fit. I hope this helps, and if you need more info, just let me know 😊
Very flash bit of kit would love one
Thank you. I have thought about making more, but I need a new welder first to dial in my welds 😄
Dam !! I watched the whole video and didn’t see you showering 😢
Haha yeah sorry mate. That's exclusive content only VIP
Nice work, but sorry I don’t get the point of pivoting the shower tent 🤔
The whole point is that it swings away from the rooftop tent and allows the tent to open while having the shower tent alongside the tent. Also, it gets it away from the side of the camper. For my setup, it works great, and many people are even using them on their cars as it swings out from their canopy.
Stands out like dogs balls!
In what way do you think it stands out?