Video

Use something like credit card or guitar pick, they have locking tabs on the bottom. So insert card between connector and the housing. It's tricky a bit. Don't force it too much, or they would break. They work even broken, but better to save it. The one that closer to the wires, should come off first. Hope it helps

Well I have broke it 🤣 but yes finally I think i got it. Mine was completly riped off, I have to figure out by logic which wire goes to which connector. After 4h i think i finally got it omg

I used Autel, but anything alike that can read steering wheel angle sensor would work.

If you mean the ones that stamp welded to the housing, then you just carefully pry them, or cut welded area with utility knife

Absolutely, you can install any fixture, as long as it sits right on that ceiling section. The reason I put bmw one is because it was 8$ versus $150 for oem

Ground from the valve goes to the ground on control module, it's green wire in my harness and it says GRND on the module

Just buy a new one, it’s like $60

@@LuLu-eb7lt I needed a car for a weekend one day to repair I prefer to repair than buy new

Possibly, I'm not sure tho.

It should be. Especially same brand. And if they have same supplier, it should be very similar part

It's just control valve, your btu shouldn't change

Guess I should of waited till end lol

@@BouviaFamily yeah, ended up dropping it lol

Sorry man, too busy with my never ending projects. My brother had some issues on his g8 few years back too. But I didn't get involved that time

@@fixxxer6484damm it, the problem is that,i cant find a replacement part not even om the dealership, does your brother have a chanel so i can ask him?

@@JesusRangel-kn8hl he doesn't. What's your issue? Tell me I'll ask him. He had issues with some switches I believe. He got another steering wheel, and either side didn't work, If I recall correctly. Try Australia. They are flooded with g8 over there. AU eBay might work for you.

@@fixxxer6484 well the issue is te clock spring, no power on the steering wheel, air bag light on, and buttons dont work, i know they have a car name holdem ve but im not sure if it fits on mine since the part number doesnt match

@@JesusRangel-kn8hl if you find the one that looks the same as yours with buttons, it should work, even parts numbers won't match. Or you might consider to get entire steering wheel with clock spring included.

Do Silverados have common issue with that too?

It might, but as I know the airbag being triggered by high current, so it shouldn't be hurting deployment timing.

That might work too

I believe hardware stores sell it too, or online. Friend of mine gave me one, so I didn't have to buy one.

Because its intermittent pilot, which saves you gas, it doesn't burn gas when not in use. Its kinda having updated furnace in old body.

Smartest comment on this video.

im not sure, messed up with youtube studio and their rights regulations. Is there any spots where there is no sound? Thank you for hint.

I remember the background music was really loud at some points during the video. But didn’t notice anything this time👍

I dont really understand what's happening to your rear camera

Fixxxer you know those yellow lines that pop on the screen when when you put the vehicle on reverse? There supposed to be straight just like the steering wheel right? Well i got my steering column replaced at some point and then after that the reverse camera was not the same no more, the yellow limes do not match up to the steering wheel

@@fivestarhemi2877 do you have traction light on on the dash right now?

Fixxxer looks like a Christmas tree to be honest, even the check engine light came on

Fixxxer i will do a video when i have a chance & tag you. Thanks in the meantime

Thank you Nick. Yeah, I was speechless, when realised how dangerous old system was

Not really designed to be repaired, but as you see, can be done. Mine still works 💯 after I redone all contacts, even those which were good at the moment. Eventually they all gonna break. Just do them all while you there.

It is ))

Possibly it's column itself, not the clockspring, not sure. But very few chances it's dry, even so, not much to click inside of clockspring. High chances it's something else

@@fixxxer6484 I don't think it's the column it definitely sounds like plastic scratching plastic. Definitely coming from right behind the steering wheel

@@blakeerdmann take steering wheel off, and inspect it. With wheel on, it's hard to tell what's going on under it

@@blakeerdmann Im going thru this right now, did you figure out if it was the clock spring or not?

@@misaelroman1215 no. Sometimes it does it and sometimes not. Im thinking it's the clockspring though.

Check out my conversation with Guilherme Martins, I explained here in comments where the sensor is, and couple other related things. Just look the comments up.

By chance did you disconnect your battery before starting to pull the steering wheel off. I have seen videos some disconnect the battery some don't, what's best. I am assuming not to disconnect the battery because you need to use the scan tool?

@@marcusslaten8806 if you're not much experienced in car repairs I would suggest you to disconnect it, before you unplug steering wheel airbag. You might need to turn steering wheel left and right, and it's easier on running engine, so after you remove bag, right before disconnecting it, put your wheels straight and then disconnect the battery, and then bag connectors.