Video

what size is the "repair" sleeve for the yoke?

Does your cab rub the tank?

Thanks for the video. The music in the background is so hardcore lol

Horrible music. Better off without it.

The sensor comes out easier if you twist before trying to pry it out.

The whistle comes from the turbine wheel in the rear of the turbo.

NEVER EVER electric! I will give up driving for good and get myself personally castrated before I would even consider electric.

Electric of course

Diesel blow the tesla up

⚡️ for everyday Diesel if you actually use it for work otherwise pointless to drive to mall and grocery store

Diesel all day.

Diesel. Diesel all the way

Anyway did it work OK? Is it leaking at all or any other problems

I did my truck and when I put everything back it wasn't exactly the same I didn't want to force it back to where it was maybe is ok

Another reason why men never get to see their grandchildren 😂😂😂

Always been good for it, never used hard No lowballers, I know what i got

It's a beautiful beast! 😮

Nice video..short & simple. In my case (98 12V 2500) the whole bolt assy came out as one, IE the bolt came out of the pumpkin instead of the nuts breaking free. I would add a step to what you outlined for cleaning the top of the pumpkin prior to removing the sensor so all that road crud doesn't fall inside. I used a 6" wire brush to break free all the road grime and some air (canned or compressor) prior to removing the sensor. Especially important since I just flushed all of the old oil and just put new oil in.

Says a Detroit diesel is junk. While driving a pos ford diesel.. nice clickbait chump.

Good job kid!

What's the part number brother?

Thanks helped me

How long would you say it takes from start to finish?

Thank you for the blaring music. I love watching videos on mute.

Hey Just came across your work. How did it work out ? Good to go ? You still have truck ? Excellent video tutorial

Nikal barwe

Music Sucks

All Dodge ram always leaks

I dare you to go down a dusty road , or a decent river crossing.

Are you Shure that's a genuine Holset turbo, the reason I said so is because Holset turbos whistle very loud even during idle

Did you show how to undo the clips.......NO

Why is the reason for replacing?

use a puller not a rubber mallet to get the pinion off so you don"t cause yourself other issues. the little thingy, thing amagiggy is a called a reddi or speedi sleeve.

Love it! I have an 02 f350 lariat 7.3 im building cause I got my dream truck!

Best video I've seen on seal. Great job

Anyone know if this also works on 1995 dodge Cummins?

Mine started doing that and every the rpms jump while I’m driving.

Please label the title "How NOT to make your turbo whistle more"

Really clean truck, is it 2wd?

2001 Dodge Ram 3500 2nd Gen Manual transmission does not run has fuel pump issue asking $4500

I had my abs and break light come on after doing burnouts lol think this is it or would it be something actually wrong

Good idea to take a part off that was sealed from dodge engineering to make a louder sound🙄

These are loud and annoying

Also does that sending unit make any noise while operating or is it quiet in other words with the truck on or the key turn can you lay under the truck and hear the sending unit pumping fuel?

Does that sending unit have a pump built in it also ? Or is it just fuel level and vent? Thanks

👏🏽 Great Video! Much appreciated, very useful!