Video

🐂😍😘 just gorgeous 🥰

The Highland bull. 🏴󠁧󠁢󠁳󠁣󠁴󠁿 Scotland the Brave. I love him. I want him in my backyard.

My hot water taps throughout RV are spurring and pushing out air I supposed I need to check that valve and replace it since I am not sure why else would hot water spur when cold water not

Could have done without the music

Beautiful

Not a good idea to use an impact on a porcelain lined tank.

I am grateful that I can simply watch this amazing birth of life from home.. Why does the mother cattle re-ingest the placenta?

closer / back / jump / stay / etc

Just beautiful ❤️

Thank you for the video! I'm dealing with low hot water pressure yet have strong cold water pressure. I also found a leak on the twist plastic end on the check valve. Thanks again! Great video?

Mine was in same position at top of tank. It was plastic. I thought at first it was plastic because they went cheap. But after I put the replacement one made of brass in, and it works fine so far, I read on a forum that different metals can fuse together. I did use Teflon tape so there is a barrier between the metals. It’s a 10 gallon Atwood which is aluminum. I think the temperature for electrolysis may be a lot higher than the temperature of the water heater, not sure. I don’t want to take new valve out and put new plastic in, as this was a very difficult job due to the location of the back of the tank. I noticed your replacement was brass and I guess the one you took out was original from factory? What are your thoughts?

Just a thought, run your equipment ground speed where it does not bounce and jostle. Different ground conditions different speed, smooth is fast. Brake your equipment and all that time one thinks they are saving goes out the window and rains coming. The wear and tear will catch up costing money and time.

Hi! About how long did this take to replace?

Wheels raking put dirt in the hay. A basket rack don't

Thank goodness for your video I watched tons and couldn't figure out my issue but your video helped me put my puzzle together!

She's a darling ❤😘😍

My "T" winterizing diverter went bad. When I took it out and blew into it - it worked fine - but when I connected it to the bottom of the T side and turned on the water it flowed through the other free ports. So blowing into it and turning the knob is not a valid test. :-( I did all of the work of replacing the check valve and only needed to swap the T valve.

Would have been interesting to see how mother would have straightened out that twisted mess she created.

I was in the same boat. Hot water for maybe 30sec then nothing. My brother in law had this happen as well, so he said I should pull and check it. Well it ended up shooting out (the inner valve itself) of the brass housing. I ran hot water with great success without the valve the rest of the trip. Bought a new one when we got back home, now I’m putting that in. It is a BITCH to get out. My hot water tank is under a hide a bed. Hard to get to. The impact…. Great idea my friend!

I was very interested in the video, but unfortunately i couldn't make it through the music.

What was with all the licking?

You apparently use Home Depot spray paint for your hives as i do. But I prefer oops exterior paint now

what makes you think I came to your channel to listen to crappy music.

As music goes, it's really nice. Too bad I can't hear a word you're saying though...

you did so well the first half of the video. then you stated calling it a "hot water heater". why would you want to heat "hot" water?

omg that little calf looks so darn cute!!!!!!!!!!

How hard are they to fold in n out?

👌

They look good all brushed

Aww goid job girl

Highlands are the cutest cows and I'm glad they're allowed to roam free. I wish they did the same in those factory farms...animals have feelings and we should give them a good life...but also a peaceful painless death as well...I've heard nitrogen euthanasia might be best.

That’s so cute!

I like the part where she said “moo”

Your herd looks in really good condition, the bull is huge what do you think he weighs?

Good job to that momma.

You've got a beautiful girl, lovely cows and a great little farm. You're living the dream.

I had a friend who had both highland and mini jersey. He would take the mothers and calves four days after they were born and bring them in to milk the mother in the morning. In the afternoon he would milk her again and use the morning milk he took to feed the calf. He said this both forced the mother to observe his care for the calf and also teach the calf his intent which would later translate into greater trust. Anyone could walk into his pastures with him and the beasts would flock to him and in very short order also come to you once they observed you were with him. The friendliest animals ever. And the newer the generations got the more trusting they were. He also strove to be present at every birth so that the calf would see him and know humans are a normal thing. Additionally he leased out his calves for 4H and petting zoos. This all helped his herds become truly human friendly and loving.

Give the damn baby to the mother

So sweet when the cows are using each others horns to get scritches. That's love ain't it?

Stop bothering them...... Let tha calf drink milk peacefully..

Mum not happy with the guy filming and talking☹️☹️ She needs privacy.

Cute cute cute. No words describe their beauty.

I love highlands, they're like the hippy's of the cattle breed

Give her life. You have space you have a lot of food.

Cutie and go away from my child. Cute Mum and her baby.

Such Beautiful Baby

Mum cow is uncomfortable with some human filming.

Bought one fucking junk don’t buy broke out of the box

Just pulled mine and took the guts out until I can get a new one. Easy fix.

Sorry, I changed the frame rate a bit and some other setting on the camera, it seems a bit jumpy when moving and really bright. Will be making adjustments for the next videos.