Video

What are the chances of it gettinf stuck full throttle with out the tor because u couldnt turn it off when it got stuck full throttle & the kill switch was not working what so ever

I need a impeller seal

That’s not fun

Very informative thank you

Thank you for the tips great video

I have one,need to get some parts for it, I live in trinidad

2021 and you saved my quad thank you

After tors delete can u still use stuck throttle cable

Try not to leave wires dangling thatre taking power / being powered safer to tape up isolate zip tie hide etc and dangle but anything better than just dangling helpful vid sorry for nit picking ✌️💪

*Thank you so much this is very greatly explained my blaster would not start at all then you said to remove the brain when I did it started right up thank you !!!*

Blow your nose ffs

tip for better tutorials: stay on topic

Tenho um6 desse semi novo.vive guardado so esquento.algumas vezes por mes

What throttle cable do you use once you remove that brick from the carb

Do they still make these?

Thank you very much extremely helpful THANK YOU!

After watching this I am left more clueless than before as to what a tor is or why I would want to remove it

So I had the boggling down issue when I throttle my 2002 blaster. Followed the video step by step, my connectors and plugs were different however the cables were the same. After 10 minutes of cranking my blaster it turned on and had no issues. Great video and thanx.

Perfectly explained .Thanks 🖒

hey nice video..where does the orange wire from the ignition coil go..

i dont feel like tearing into my harness and this is too hard to follow without doing so. still a helpful video fornunderstanding lol

Olá amigo você ainda tem essa motobomba sthil p840 se tiver você vende?

Dude. So helpful.

just brought a blaster for a drag build and the it kept bogging out thank god you made this video now she runs like a champ

call me at 1-304-619-9646

On the wires for the headlight the green, blue and brown which one is ground and which one is for brights?

Thanks great video...very helpful..

stupid , wires are there for a reason, if it dont run right there is another problem. idiot

No when throttle is stuck open good luck getting off its cheaper to replace it

Excellent video thanks

hey my blaster runs great with no problems but still does not idle on its own I replaced the throttle cable because tors was removed I added a idle screw,, new fuel filter and still no idle please help if you can thanks

Let me know sir if I could have a minute of your time? :-/

what are the wire that go to the top of the carb on a 1999 blaster? its called the switch assembly. whats its purpose? what switch?

hello everyone im here because im trying (and going to succeed by the way (:) to get a better spark out of A customers blaster, the set up on this lil blaster is very similar to my mx175f yamaha and i know my bike inside and out as well as many other older yamahas because i love to ride them so i have to know how to make them run. any way heres a few little tips that may help someone out- 1st of all when you have no/weak spark clean every plug in and ground on the bike, it does wonders. next remove the cap at the end of your coil wire so you just have the bare wire at the end where the plug goes and put that up the motor and check your spark then, this eliminates the plug and plug cap from the mess of what could be wrong. Also yamaha cdi ignition boxes are notorious for running fine when cold then as they warm up they fail and backfire and just crap out. i have bought a bike or two before warming it up fully to test it and believe me when i say i learned this the hard way. And last open the cover on the left side of your engine and check your stator and flywheel for rust/dust or moisture, and be sure to seal that puppy up when you put it back together especially if your a fellow mudder, it will save you tons of problems later. oh and please please check all grounds and make sure they are metal on clean metal like a spot of unpainted frame, i added 3 to my mx and i can now hear my bike spark.

So is this system just for cutting out spark? Because I have spark on my but still don't fire. It might be a carb issue but just curious if this could be my problem.

My nephew has a 96 Blaster that will not run. We removed the TORS system as you showed but we still have no spark. What do we do next, any ideas?

I did this to my 88 blaster today didint work idk y bit any one help me??it was running the other day but when I would try to drive it it would bog down an die then I lost spark have no clue why

dude you r a genius i got 88 blaster i disconect all this shitty tors like you said and bang its run like a new thanks a lots man !!!

I am having a problem I have a 02 blaster I just rebuilt the motor an now I aint getting no spark im getting power to my regular but nothing nowhere else I thought that the startor was bad I went am had it checked came back good im stuck I dont know what else it can be I have thought about removing the tors system but I have my douts I dont want to start cutting on something that aint the problem thanks

you sound like nicolas cage good video

I just simply unplugged my tors due to a spark issue, removed the switch and still had no spark. Replaced cdi box and it fired right up. Tors obviously wasn't the problem and now it's gone I will never have that problem of it failing

hey man i have a 2005 blaster, the wire that comes off the microswitch goes to a boot plug which goes to the "brick", if i unplug it will it be uninstalled? I think my tors is messed up, blaster turns on but when i give it gas it just sorta sounds like a traction control sound on a car, good vid but idk if mine is different.

hey man wanna sell the bottomend outa the blaster?

Hi do you know if my blaster has the TORS problem? I made a video of it. Could you have a look at it? Thank you! youtube.com (slash) watch?v=8mq9YupKKWQ

Where do you adjust the idle? im not sure which screw it is.

Ok people..just unplug it..then at the plug coming from harness tie the two together,then at the throttle ,adj the cable so u got slack or play..then adj idle under seat to idle ,,...DONE

if u unplug it u wont have to get this crazy...wow

Yeh mate mine the same lost all spark to wen took off tors system been told to disable park brake switch too because that can be messing up the spark also

i took the TORS system off and now has no spark..What do i do?