Video

Merci beaucoup ❤❤❤❤❤❤

Merci beaucoup ❤❤❤❤❤❤

Merci beaucoup ❤❤❤❤❤❤❤❤❤❤

I do not recommend installing this type of air breathing catch can. The proper catch can should be a non air breathing or closed catch can and should go back to the fitting you capped off.

Any tricks to get the threaded seal retainer out. I've soaked it with penetrating oil, heat, used a 1/2 to 3/8 adapter on the 4 pin tool with a pry bar,also with an impact gun and it's not budging. This is the first time the SC has been apart and has 105 hrs. The intercooler was leaking so the SC has a little corrosion inside but i caught it early and can't see it making the retainer so hard to remove. I've onlu used a heat gun but it was hot enough for the o rings to start smoking. Maybe more heat? I'm worried i'll snap the housing mounting tabs connected to the maintenance fixture off i'm cranking on it so hard.

Thank you so much!for this amazing video :D

how to set the clock?

which depth finder was this ?

I have a 2020 GTX 300 Limited with the ST-3 hull (acrylic}. I'm finding no real definitive answers about how to repair or successfully work with this material. Someone rammed the nose into a dock. Seadoo doesn't even offer a replacement hull. Some patch using regular fiberglass, but many say it won't hold. Have you had any experience with it?

Not only are your videos super helpful, but you have been responding to almost every comment for the last 6 years. That speaks volumes of your character and commitment to the ski community, Unlike most of the other fruit loops who make vid and move on. I believe I'll subscribe. 👍

Very professional. Thanks for sharing

So it was a gasket on the fuel pump or the filter?

Can vinegar be used on new 2022 Yamaha fx SVHO jertskis?

No issue with any of this, but a bit of a stretch to call it 'improvements' I think.

Hi, I have an 2002 gtx 4-tec SeaDoo bombardier and I put the key in and I get a long beep and the dash comes on but won’t start. Then I unplug then put it back in and it pops a fuse do you think my dess post is bad?

Well done! I'm looking to buy a 2002 GTI. Looks to be in fantastic shape. Anything glaring about this model?

Pretty sure I sucked up some stuff today on my gtr 215. Was running very well hitting top speeds with ease, the first thing I noticed that was odd was the ski doing low speed while I did not have much throttle in. I hit the throttle again and it reset, then it started shuddering a lot, gave it a good shake but there was still something stuck in the impeller, major vibration. Had to take it into the shop regardless for a soft supercharger rebuild before going away. Hopefully everything works.

I have a 2024 900 RP, I can only see 2 screws to remove the front beak, anyone show mw exactly where the 4 to remove the beak are exactly?

Have a 2004 seadoo GTX supercharged. Had a new battery last year, ran great. Put the battery back in this year, ran perfect first use. Went to ride again a few days later and battery was dead. Put a new battery in and it keeps beeping like I have the key on the dess but I do not. Seems to be a short somewhere. Any ideas?

So we haven’t started our skis in a couple of years. Garage kept. What do I do and what do you recommend. Thanks.

Turn off the damn music it's irritating

This is somthing i just experienced. My absorbor cracked at the where the swivle bolts hold in the seat s shock support, not sure of the name of it. Any how i prefer the nut and bolt instead of the rivets. And lowering of the bracket is key. My glove box is always getting stuck.

Je veux d’amande Kit Pastille de Soupape pour jet ski yamaha fzr 2016

Je veux demander Kit Pastille de Soupape pour jet ski yamaha fzr 2016 4:43

Je veux demander Kit Pastille de Soupape pour jet ski yamaha fzr 2016 4:43

Je veux demander Kit Pastille de Soupape pour jet ski yamaha fzr 2016 4:43

Je veux demander Kit Pastille de Soupape pour jet ski yamaha fzr 2016

how do you know when the steering is straight? Is it like a half turn, full turn?

Can we use any type of coolants?

Worthless video. Never once talked about dewinterizing ski. Thanks for wasting my time

Thank you for the video, i have only a question about the expansion tank, when do you drain the coolant fluid also the expansion thank became empty or i need to do something, thank you so much

I have a 2023 Yamaha FX HO Cruiser… can I do something to that to make it faster at all?

Hey! Amazing Videos. I have a question: A friend of mine has a 2016 GTX 300 Limited (Gen 2 IBR I think?!). He wanted to clean the rear pump assembly and lowered the IBR using Override while on the trailer. He forgot to take of the license-plate bar, so when lowering, without noticing, the IBR was pushing down on that solid metal bar for around 5 seconds. After realizing, he checked for damage (nothing visible) and functionality (movement in IBR-Override seems fine/unchanged). Best take it to a dealer to check nothing in the IBR assembly cracked because of this, or will it be safe to assume its fine (does it have a pressure sensor that made it stop or would a fuse blow before any part gets truely damaged? Owners-Manual says the IBR WILL get damaged if blocked in IBR-Override...) Thanks in advance!

Hello, Love your video I just installed a brand new IBR unit on my 2012 GTI SE 130. does it need to be programmed? Do I need to take it to the dealer? Please help thanks

Should I remove the flange nut first and then the impeller? I am not trying to rebuild the pump my bearings are good, just trying to put in a new wear ring.

Hi I have a 2001 rxdi seadoo I took the fuel pump out and replaced the 2 filters ...put it all back but the jet sky won't start now. I do see the pump skirts gas from the nozzle but the motor cranks but no spark unless I put some starting fluid in the piston and then put the plugs back.... could it be the pressure of the gas tank or could it be the fuel lines are clogged the ski has 52 original hours

because the sea doo supercharger releases a lot of white smoke from the exhaust?

Pretty sure that was two stroke oil in the motor based on the color…. Now I’m wondering if that is the secret to getting 900 hours out of a ski lol.

How did you prepare the tank? I used Kreem some time ago but it didnt work for me, TankCure did wonders for me. If there's even a speck of rust, the liner will not adhere there and thus create bubbles. And bubbles pop, and create bladders. My advice is a thorough de-grease, plush with water, add 200ml isopropynol , shake well, empty, blow out with compressed air. Add rust remover, flush it out the same way as the degreaser. What i found out is that if you blow it out with hot air it rusts immediatly, so just use compressed air or a cold blower. If you use compressed air, make sure its water and oil free. If you use a epoxy, keep in mind that its very viscous and needs time to flow. These are my tips. To me, epoxy>liner any time

can you elaborate more on #5 riding beyond their skill level

driving jetski for first time in a week any tips

Hey guys got a question i have a 2003 seadpo gtx 4tec. Im having a bogging when i give it any throttle but will idel no problem when in the water. Compression is good, no codes using candoo pro, no coolant loss, no leaks. Any suggestions

I have a gtx 185. there is gold/bronze particles in the oil filter and my mechanic suspects it to possibly be the bolts. The ski is bone stock its whole life. There is also signs of the engine being pulled before and we have no clue how old the filter is (My old mechanic never changed the filter). Any clue why they could possibly be failing on a stock machine?

I have a 23 rxp less than 30 hours. It a little but my handle bars have play in them. I need to learn how to adjust that. Like if I’m sitting on the ski I can put pressure on my handle bars and move it back and fourth.

Probably a dumb thing to say but I've never seen a professional shop use rigid tools. I always see Milwaukee and DeWalt.

Merci beaucoup ❤❤❤❤❤❤❤❤❤❤ Tout les travail ❤❤❤❤❤merci beaucoup ❤❤❤❤❤❤❤❤❤

I think it helped with the low rpm unevenness when maneuvering at low speeds on my 2017 Triumph 900. If that's your issue than I recommend it .if you think its going to boost the power than don't waste you money.

Where do you store this tool on your jet ski?

Hi I did the same process but something went wrong…. Right now the temperature goes up the 100 degrees celsius and doesn’t go down… the fan start and don’t switch off. Only if I ride the temperture go down and the fan stop. What i wrong?? Now I scare to burn the engine!!!