Video

Only thing that is maybe wrong is with regards to the RCCR. The upper coil is to repel the spring and force the contact open the bottom coil is to close the contact and allow generator voltage to go to the load. When you mentioned the bottom coil repealing the contact you lost me because the ground for the bottom coil at the RCCR only goes to ground at the generator other than that very good video.

To Airplaneinstructor: First, thanks for the video. Took several times watching it before it all finally sunk in. Question: Could you use a Type A (24 volt) voltage regulator with 2, 120 volt AC to 12 volt DC regulated battery chargers in series. 40 amps DC max current.

I see you are using an engine case with the ‘super air/oil cooling’ mod. @6:24 aka, hole punched in the case. You might want to do a rod count.

excellent thank you Miss Instructor 😊😊

Very nice video, even after 10 years it is good. :) I Have a question as I have one old Bosch ZAD 14V 11A. The resistor R2 is missing, and some one have replaced it with a wire. Do you have any idea what the resistance value of this could be? The regulator is not working as it should now, it is overcharging. :(

One of the better videos. 99% of them have no idea how a charging system works. The cutout relay stays connected until the generator output drops too low. Then it disconnects till you have enough rpm to charge again. Keeps the battery from draining down.

at 7:43 the secondary flux shouldn't oppose to the primary flux? thanks for the explanation,

Well I already knew if you pass a magnet thru a coil it produces a electrical current thru primary coil secondary coil steps up high voltage and causing spark plug to fire.

very good

One of best explanation of Starter generator working.Thank you very much for this beautiful video.

This is great! Thanks!

0:44

You need to point out the diagram you're using is for a externally grounded generator. There two types internally grounded (general motors / Chrysler) most Fords etc used a externally grounded. They have to be polarized different. And some Bosch generators used a isolated field which is basically a internally grounded unit. The cutout relay is needed because generators don't have diodes ! There pretty much EMP proof but the regulator isn't as foolproof. And at about 1300 rpm the contact points are vibrating about 1000 times a second. Not a bad video. Take care.

Im interested to know can alternator magnet type use such voltage regulator? how much I did understand it wuld send continues curent and high voltage to the regulator. I dont have availabel solar regulators in my land and actualy I wanted to see if tractor delco regulator wuld help my alternator charge baterrys at low'r speed ranges or use avr or other closed loop system that has nothing to do with positive or negative on the alternators side. So Im woried to fry my baterrys so wuld it by posibel to use those old dc systems like current cutt out selenoid and similar? Honestly I love engine conversions and to use hv capacitors for plasma and amplifier ignition systems so I come across unusual problems my delci 12si cutts in at higher rpm rangers or starting charge get activated at 2500-3000 rpm and Im cinde if anoyed at that thing. So me other question wuld by how to calculate voltage and amps going to the rotor and specific alternator speed ranges wuld it by possibel to manuali set fixed alternator out put via resistor/capacitor box? Peopel are not specific about those things . And last but not least what wuld happen if you reverse direction on the alternator ? Expecialy on tractor alternators I found out some of them wont charge baterry if you buy wrong alternator turning direction and if that external capacitor is dead the alternator wont charge so is there by any chance logical explanation why this happes?

Good work

I remember years ago many years ago and there was two types of generator systems I think one was an A and the other one was d circuit

Thank you fir the explanation. It helped understand what went bad on my friend buccaneer

Fanshawe students hit like button

Great explanation. Thank you.

WHY are you using a RADIAL ENGINE Time.rite; when both Lycoming, And Continental have t heir timing marks on the prop flanges, and the reference marks are on the crankcase? All that you need is a mag synchronizer, (two lights) to time the mags to the engine. Takes ten-15 minutes.

I’m working on a 1946 Funk it has a Delco Remy generator and voltage regulator the wiring diagram I have is unreadable. Could you add the master switch to the diagram. The generator itself Test good grounding the field. Hard to see behind this panel but I currently have no charge due to wiring or bad master switch and that system.

What purpose does the Capacitor serve wired parallel to the point gap?

Hello, I am French, and I have modified a 6v 40 A electromagnetic regulator into an electronic regulator and all this in the same box watch my video on my youtube channel best regards

My battery drained I replaced voltage regulator 3 times. And repaired generator 2 times and still have problems not charging battery and when I turn lights I loose power

Can a regulator from a 1940 Oldsmobile six volt system be used on a 1951 meteor six volt system.

Great job, well explained

So can a aircraft engine be started by hand propping with battery on and mags on? Or does a starter switch has to be used to to energize the vibrater?

My 51 olds&52 have the same concept

Excellent job explaining!

Excellent video and many thanks to the kids for teaching this old man how to set his 4371 mags.

Going for my A&P mechanic certification and watching this video of seeing this in action is so cool! Got to construct and solder a magneto synchronizer that looks exactly like that but with a different tone and works like a charm. Thanks for the video!

If the current limiter contacts or voltage regulator contacts open, doesn't the field current still have a flow path to ground through R1? If that is the case, the field current can still be maintained, thus never decreasing generator voltage. Help me understand if that statement is wrong.

Statements are contradiction 1st polarised and not. When relay is open writing electro magnetic field when relay is open very confusing I need skiped to other video thank you 1st 4minits but statement & writing are contradicting I love driwing exponation thank yohbut whem cirkit are open please do not drow current still flowing on open cirkit

Amazing explanation. I love it.

My question is as we know v proportional to I can be used a resistor to increase voltage drop and reduce current amore loss can be covered in terms of flux in the winding except the heat dissipation is more.

They missed the explanation of the capacitor and why it's needed.

I really should not have looked up "starting vibrator" lol it was the first one tho

Great video!

Thanks for this very lucid explanation. I learnt a lot from this.

Excellent explanation and presentation, thank you!

I don’t have an exam on this, in fact I have no idea why I am watching this, it’s 11pm, 1st Jan 2021 and here in the UK we are in lockdown due to the worldwide pandemic. Who ever would have thought this when this vid was made?

Well taught

I Still don't understand what R2 does, please help.

Great explanation. Thank you!

Very nice job on this explaination . The fine control of this type regulator is a little involved but this video covers it so it is clear. Good learning tool.