Video

Swap the wires on the ends of esc,the one that goes the opposite of your wanted direction.. your current is fighting it's self and so this here u made is a slow cooker bunnerupper

where you concerned at all, about breaking the landing legs because of the heavy weights and the way that you attach them? How did you do the attachment point?

Yes you can I've done it connect 3 phase wires in parallel

Obviously resonance from crank end to gearbox... Shame this was so long ago cos I'd ;love to know which conversion kit this was.

Consegue me mandar o esquema elétrico ??

Hai

Thanks, exactly what I was looking for!

I mean, it works! Next time spend $5 at harbor freight and get yourself a stepped drill bit 🙂

Thank you! Bought my car off a friend who's been driving for years with it as MPH in a KM country 🤦‍♀️ so thankful at finding your video as less likely to get a speeding ticket now it's not guesswork! 😆

In case someone is interested: this a three-phase BLDC motor, in outrunner configuration, wired in a Wye configuration. Each phase is wound in 3 sets of 3 coils, with each set of 3 coils spaced 6 coils apart (ex: green wire feeds the phase that uses coils 1,2,3, 10,11,12, 19,20,21). In each set of 3 coils, the wires are coiled CW,CCW,CW (CW=clockwise, CCW=counter-clockwise). The magnets are glued on to the hub in a pattern that alternates between North and South. The magnets don't totally align with the coils, as there are 27 coils and 30 magnets. For the 200W version that I have (the one in the video is 350W, so the numbers are different): for each phase, there are four wires that are coiled in parallel and each coil is wrapped 16 times. The number of coils in series and number of times the wires is wrapped around each coil determines the voltage. The number of wires in parallel increases the max amperage. From the video, it looks like there are 7 wires making the 6-coil jump, which makes sense, because if 4 wires allows for a 200W capacity, then 7 wires should allow for a 350W capacity, as 7/4 = 350/200. That means there should be 7 wires in parallel for each phase, coiled 16 times around each coil in the phase's pattern.

ATTENTION: Do not drain cooling liquid on the ground unless you want to potentially poison any house pets in your area, be them your own or your neighbors. Cooling liquid is also supposedly sweet which just makes matters worse as it may attract animals to drink it, but again, it's poisonous and will result in death.

Loss of watt and lower speed

Yes, try conneting the 2 motors in off , without the controller , remember that kind of motors are a gen to , make some turns to 1 motor &see whats goen on with the other if its not turn at the same side interchange 2 phases till you got it !! Sorry 4 my language im just try to help 😜

thanks

It good of you

That's what mine is doing just now. It literally will not pull it's own weight out of it's parking space until it's warmed up. I'll get on to the garage and try replacing the glow plugs. Thanks for the video!

I rewatched the video because of the music its fire .. who is the artist?

I spoke with somebody regarding 2 motors 1 speed controller as long as the motors don't overload the amount of watch that the controller makes it works 2 2 50 W motors would run on 1 500 W controller I think

Man why didn't you speak and explain what's going on instead of using the music what have been so much more helpful

hey! im display is doing exactly the same! what should i do?

Promini PCV ventil tj membranu, očisti separator ulja ta plastična posuda ispod čep od ulja. Ulij liqui moly motor clean u ulje 10 min rada, pusti i neče više pravit probleme.

Which screw size did you apply as extension? M6? M8? M10? Thanks

Пипец а не видео, для дебилов

was there any error code via diagnostics that the heaters (glow plugs) don't work.. ?

Hi I did correctly but the phone don’t want to show me pourcentage :(

thank you

Same here

could someone explain why bad glow plugs would cause the smoke. im having glow plug issues and need them replaced and mine also smokes a lot when started but I didnt think the two were linked.

Not on an ESPACE 4

great project - terrible music

What was the problem heare i have the same

Use old battery u can soldering to tha wire To get much high capacity I hope u understand my English carabaw 😂

Hello my friend. Can you please give me the name of the electric box and throttle u used. Thanks in advance

never use tap water as coolant, it will leave mineral build up on thermostats and sensors, and make the car go to shits. only demineralized water or real engine coolant. airfilters are great too if you want you engine to survive a few years :D

My segway is broken at least only one of the wheels that won't move but the other one does and I have been waiting for a month now for my parents to try and get the motor out of the wheel but the motor magnets are that strong that they just can't get the motor out of the wheel and my parents are just not going with my suggestions to get it out I'm really getting bored of waiting and it's annoying just watching my brother happily playing on his whole I'm indoors bored as hell any suggestions you can help me with to get the motor out of the wheel😭😭😡😡

If iPhone user's do this thing 😂 They lose apple branding 😂😂😂

TURN THE MUSIC OFF FFS....

How long dose it last

thanks for just showing us your controller.. hahaha You do realize that people don’t watch CZcams video so that they can go read comments for information right? We watch video so we can be told what’s going on along with visual aid..

one of the simplest way to weaken the motor's axle. from a solid axle to hollow. will break very soon.

Tell me you're not sure how to use vise grips without telling me that you're not sure how to use vise grips

What a waste of time.Pointless video.showed me nothing

Thanks so much it really helped

Question. You removed the front undertray. I have a Megane it also has the 3 10mm bolts. But the trim is attached by torx type screws to the bumper. Yours seem to have been removed. Did you remove them? If so what size, do you recall? Cheers

How much

when changing coolant on rx4, it’s the same as this video?

So in conclusion chinesse boys switch colors wired with dash panel between yellow and red ?

Its normal,when turbo kicks in , there willa be underpressure. If not,means that there is a problem with filter-turbo pipe

Thanx birathar

Gn anyone know how to take off the voice recording