- 1
- 24 898
Lasse Kristensen
Registrace 23. 08. 2013
Kawasaki ZX6R 2008 Engine problem? Ticking...?
My friends 2008 ZX6R has developed an engine problem.. what is it? Sound like valve ticking? Maybe low oil pressure? But no warning light? Or what could it be? .. another friend told me that this is a common problem in my movie for that year. But he is uncertain what exactly causes this, but he says ultimately the engine will seize up! :-/
zhlédnutí: 24 907
Me pasa lo mismo pero en frio cuando calienta se le va y suena menos qje esa
Its your cct
Oil cct
Camchain tensioner. It is very easy to repair.
CCT needs adjust easy fix
Cct
What was it ? Cam tensioner?
its timing related. get new timing chain and guides easy fix. not crank etc. cam chain and new cct 150bucks repair
czcams.com/video/A9bfKuSVpHU/video.html&ab_channel=stevenet15 <---- Solution thumps up
sounds like cct issue
Cct
CCT
Cam chain like comments below.
Mines making the same sound on cold start but just after 2 seconds sound normal again, strange
Tuve el mismo sonido y no era el tensioner chain Destapamos motor y resultó ser un pistón que partió la falda por recalentamiento y falta de lubricacion
cuánto te salió la broma
big end bearing
hope you fix it Lasse
Can chain tensioner
Its youre camshaft i have the same bike and also had that problem. To low on oil...
I have a 07 ninja zx6r and my noise was the stator bolts backed out and was grinding against the flywheel.. Hope it helps any of you
Whats stator bolts, u mean starter?
CCT
what was the issue? camshaft?? or cct??
That's not a cam chain piston / rod bearing
i have the same problem since yesterday with my Zx6r 2006!!!! what was this finally? i left my bike in my mechanic, he said its piston and ring problem and need the new motor !!!! :((((( help me please!!!!i have to mention that i didn't chanage the oil and oil filter for 4 months and after 5 days engine off, got into road with 200 km.....which damaged the bike in 30 min...
Hi there, i own Yamaha R6 and bought it after crash, i didn't hear engine cause it was oil less ( see my films ) and sound was as this, it's very popular, but after 6 months i found the problem probably your is the same. i checked spare parts and solution in Kawasaki is similar. See my films and check your bike good luck
It's your valve shims that are going bad. I had the same issues with my zx6r an I ran new moble 1 oils an Lucas in it an it helped quiet them down but if the start to federal noisy again they have time be replaced.
That load sound is valve shim?
Tattoo's by Kaiden
Rev Head could be
Kawi tick all of th do it even mine. A small timing adjustment is time consuming and could be costly
HA Couldn’t be more wrong :)
What was the problem?
Please tell me it just need a valve adjustment.
It's crankshaft
chain tensioner
ymaniac07 isnt that loud
hello! I have the same bike (zx6r 2008)and same problem as you. how you fixed this? What was wrong? Maybe oil pressure? Please help me
If you ever have this problem again or somebody told you otherwise,99 percent of the time it will be your cam chain tensioner has yet to pop itself to the next tooth. The stock one is automatic meaning it's got a spring loaded "rod" with teeth that can only go outwards and not back into itself. You can adjust it yourself but if you are not familiar with its function I would not recommend doing it yourself. The unit is located on the stater side of the bike at the bottom of the head were the right above were the head and cylinder jugs meet. By loosing the center nut a bit as well as the smaller top nut, you then slowly begin losing the bottom nut. Slow and listen for a "click" and sometimes you can feel a little "pop" if you will. Stop turning after one click as if you go to far it will click again and you then have to take the unit out to reset or your bike will then sound terrible and not be happy. Before anything try this or install a manual version and get to know the inner workings of your machine. Itll thank you with many years of fun!!!
I Just bought a bike at the dealer same exact one - but it seems to have same problem i called them and they told me for that model motorcycle its normal but to me it doesnt seem normal - did you find out what it was ? i am thinking of taking it back to dealer so they can fix it. it only happens on cold start.
if yours sounded like this one in the video, its definitely not normal. have it check, or you might cause more damage to your engine.
yeah thx - i went and dropped it off at dealer and the guys said thats not normal and told me to leave it there to get fixed - i will drop a msg asap with what the exact problem was when i find out after they fied it.
Giovanny Chavez ever found out?
yes well my problem was OIL level was too low so they maxed out the oil level the bike can handle and it fixed my problem it was clicking clicking clicking but adjusting oil fixed the problem. i had taken it to dealer and they re did whole top and problem still came back but when adjusting the oil the problem was fixed for me.
so did you end up finding out what the problem was?
It's your cam chain man did u ever fix it
Check your engine oil too, lack of lubrication can cause a seizure.
The problem did get louder or get faster with the revs so I am going to assume the problem may be a valve tap.
cam chain ??