Video

I would like to apologize for the slight echo. I moved my complete gaming/recording setup and the walls were bare during this recording. That has been fixed for the future episodes :)

You are doing great so far, colony looks very stable except food source(hatches in long term). I don’t quite understand how you are going to use all the water you stockpile

I think achievement was easier to do using your first setup. It is really hard to make everyone work in the right part of the base since you have chef, ranchers that might do something all day according to priorities and on 1 of the day they might fail to do an errand. Also, having a shower is also an errand 😉

After swapping the nat gas geyser pump for steel. You may want to build an insulated tile in between the nat gas geyser and the liquid lock to seal it off completely so the heat doesn't leak out. Over a long enough period of time water liquid locks can boil, turn to steam and make a really big mess. If you want to retain access to an area, but completely block heat. Build two liquid locks with a vacuum area in between. The vacuum will prevent all heat transfer and the dual liquid locks allow dupes access. Good luck with job suitability! It was bugged when I attempted it so I gave up and haven't attempted it again. When you get the wrong liquid or gas in a pipe/duct, cut the pipe/duct after the packet so it stops moving and use the empty pipe tool to get a dupe to clear out the packet.

You can use the dig command to uproot plants. Enjoying your series 👍

Klei rhymes with play ;) For water I like to use a combination of reservoir tanks and tile pools to keep a buffer large enough to get through dormant periods. The empty space in the back of the hatch ranch is a good place to put tanks. I don't think the freezer box is necessary unless you are routing hot food through it to pre chill.

About water - sometimes I use Liquid Reservoir for storing, but more like a buffer to regulate temperature, especially for cooling loops. But for storing water from the Vents/Geysers I use reservoirs made of tiles like you under geysers. It is ok to have them overpressure because the reservoir is full, basically, you do not need more water than you can use :) Also, all geysers have they their cost :( The polluted water temperature is ok but requires sand. Salt water requires a lot of power, and refine machine output is limited and not stable because of dupe input. Plus is that it provides salt which is sand :) in combination with polluted water it is cool. pure water is hot or boiling, but as for me cool steam vent or water gayser are the best sources if you can handle them. So I prepare base to gather all water I can, but use sources depends on their temperatures...

To see how much critters eat, scroll down to the 'diet' section and hover on carbon dioxide etc... About revealing Vents and Volcanos, there is only 1 tile that prevents each Vent from eruption. there is a 4x1 neutronium every time (almost, I see 5x1 sometimes), you can excavate all tiles except 1 located 2 right and 2 up from the 4x1 neutronium from the left neutronium tile: (n - neutronium, x - could be excavated, N - do NOT touch it unless you want) xNxx xxxx nnnn

Build a full box... Hollow it out with a liquid lock.. then send Bleachstone thru conveyor... Chrlorine is best for deep freeze cuz it kills slimelung

I love your coffee background for the great hall, I wish I also had it :)

you can use the cancel tool to measure and count. just drag it parallel to what you want to measure/count. That way you don't have to count each mess table.

I think we are going to change the Carbon Dioxide to Hydrogen instead due to the cold temperature we are reaching.

You might want to seal up the slickster ranch a little more. It will be leaking a lot of heat into the base. The mushrooms and slicksters have very different temp ranges. The mushrooms won't be able to survive in that heat. Food rotted and created polluted oxygen in the freezer. Rotten food is able to off gas if the co2 is less than 1800g per tile. When the polluted oxygen was created the co2 either compressed to a single tile or some of it got deleted. You can pump up to 2000g per tile of gas with a regular vent and 20kg per tile with a high pressure vent.

lol. Yes, I think that you pronounced Puce correctly! Thankfully it's not pronounced "puke". :)

Hatches (smooth hatches aside) eat 140kg of material per cycle or 700 kcals of actual food.

SHC is the amount of energy it takes to alter temperature. Gold make great tempshift plates because they’ll hold on to very little energy. Copper is preferable for heat conductive metal tiles because they’ll hold more energy to move on. Diamond is even better. Aluminum is the best option before space.

Set clearance to "vacancy only" on the atmo suit checkpoint when there is more than one checkpoint. This should prevent them from dropping suits when there are multiple checkpoint exits.

The only fix I have not implemented to the Cool Steam Vent Tamer is the door being closed. That fix is coming in a later episode!

The melting points of the different metals in ONI confuse me and I always have to double check because it's not intuitive.

There is a single pipe segment behind the pump output, as steam gets pumped in it seems to be cooling enough to state change into water. Water is then able to escape and more steam gets pumped into the pipe segment. I think the new bathroom is too large for the room bonus.

The de-spagettification is very satisfying.

The only thing left to settle the Aquatuner setup is to change the door opening and closing. All that work put into place makes you really feel those accomplishments. Thank you all for the comments, suggestions, and support!

Enjoying the series. QQ: Why aren't you getting rid of some of the incubators now that you're food is more stable?

About the broken pipe - your aquatuner drops pwater temp by 14 when it is -18 :) but even when you set sensor to -4c, it sometimes will break pipe because you measure liquid temp in 1 place, and cool down a blob in the other place. you can see that temp of each blob in pipe has different values. So either use reservoir where liquid comes into it and then you measure temp and then it could be cooled/ignored OR you need pipe sensor next to the aquatuner input pipe. It hurts to see you unbox your setup so many times, I hope you can fix it before all water becomes steam What materials are you using to feed your hatches? I guess igneous rock, just check your supplies, at the current stage it is not renewable?

A little extra water in the steam chamber probably would have been fine. The steam may take a little longer to flash, but the aquatuner is not effected by over pressure. The only time you need to worry about steam pressure is when there is a volcano in the steam chamber. If I remember correctly volcanoes shut down from over pressure at 150kg per tile of steam. A liquid reservoir buffer tank will help prevent back ups on cooling loops. No need to fill it all the way, just a bit more than a full coolant line will do. The steam vent tamer only transfers heat when the door is shut. The metal door transfers heat. When the door is open there is a vacuum where the open door is preventing heat transfer. Aquatuner drops coolant by 14c, when you set the temp sensor close to the freezing point of pwater it lowered it by 14c past the freezing point. The state change is what is breaking the pipe. Putting the meat fridge on the left of the deep freezer might make it so both the kitchen and great hall autosweepers can reach it. Autosweepers can reach through pneumatic doors.

I just found your channel and right now im watching your achievement run. Keep it up man. 👍Thanks for this I did not know there is actually a way to clean germs this way 😮

Making a condensed core base with just the necessities for dupes inside is a good idea. It makes temp control easier once all the heat producing industrial buildings are moved outside or even better into an industrial sauna. Once the core base is sealed up you can put atmo suit docks at the exit/exits so dupes are always in suits when outside the core base. I like to use liquid locks just after the atmo suit exits to completely seal the base off from any gas. A gas element sensor, gas pump and gas filter can be used to expel carbon dioxide that builds up in the bottom floor of the core. You can use weezeworts in a room filled with hydrogen to cool the oxygen coming from the spom. Pump the oxygen through zig zag radiant piping through the weezewort room. I start with 5 and then uproot them as the base chills. By the time I'm ready to swap to dedicated cooling I usually only have 2 weezeworts going. If the base is sealed up and there are no industrial machines inside. Then the cooling from this method is usually enough to keep the core base in a comfortable range.

I love the videos and I'm do so much better in my current run already thank you!

I love seeing the progression & thought process it's very helpful!

Ethanol is a pretty bad coolant outside of low temp applications. Polluted water is a much better coolant for mid range temps. Compare the specific heat capacity of the two. The natural gas might have come from the gas filter. If you power them and don't set the filter they will just push gas through the output. When you moused over the gas filter it read "no filter set" No need to make the turbine out of steel, it shouldn't get very hot with the aquatuner cooling it.

I really like your playstyle with not so many pauses. Keep it up! Many people play ONI like Pause -> Make a lot of orders -> Unpause and 3x+ speed. Like there are no dupes, everything is built instantly.

Temp shift plates made of gold are not so good. If you have granite - it is better and cost less. Even sandstone should be fine :) just compare their Specific Heat Capacity and Thermal Conductivity.

You can build the temp shift plates in a checkerboard pattern to save on resources. Each plate effects all the surrounding tiles.

Add decor items in lower beds it needs 4 u missed it

If you click on a planet on the star map it will tell what meteor showers land on it. It will also tell you what geysers, vents and volcanoes are on the planet as well. Allow manual use option is at the bottom of the menu on the loader. I think the material switching to sedimentary rock is because you are using copy (b) to select the pipes from existing pipes that are made from sedimentary rock. Copy will use the materials of the object selected. There is a mod that makes dupes automatically dig fallen mud and sand, very handy for keeping dupes alive, mod name is "Falling Sand". You could run a conveyor belt through the ice box and send the food through to pre chill it before sending to the deep freezer. Items on a conveyor cool/heat much faster than a large mass in a pile.

Lore drop… the dupes are socializing with the printing pod.

A 3 tile deep pit for fridges will fix the sterile environment from fluctuating. If you seal the deep freezer with insulated tile and use an auto sweeper to pull food out it will be easier to cool without effecting the surrounding area. Set a fridge to 1 kg and the auto sweeper will only pull out enough food for dupes to eat.

Making a liquid lock and vacuuming out the steam chamber will prevent issues later on with gas in the steam chamber. Temp shift plates effect all adjacent tiles so no need to build so many, a checker board pattern will suffice. Use the cooling loop from the aquatuner to cool the steam turbine, If I remember correctly one aquatuner can cool 5 turbines. Definitely make the aquatuner with steel, it's one of the main purposes of steel and with save you trouble in the future. Look up aquatuner set ups for how to use a bridge as a bypass. That way when the aquatuner is shut down the loop will continue to flow. You can flip the aquatuner with default (o) so the loop can be reversed instead of using bridges and crossing itself. An easy early game deep freezer can be made with the thermo regulator and hydrogen, the hydrogen can go much lower than any fluids you have access to at this point. Sorry for the info dump. The videos are great, keep them coming!

I appreciate the positive outlook.

It is a wonderful series. I don't know if this is changed in future videos, but they will go to the bathroom in downtime if they need to go, so bathroom time isn't a big necessity. If you have three downtimes, you can also get a little higher morale for it.

I looked up the Pip thing from last video because I was curious. This is from the wiki. It won't let me post the link. "They don't plant a seed in a target tile if there are already 3 or more Plants within an area: 5 up, 5 to the right, 6 down and 6 to the left from the tile."

You can set the deconstruct tool to buildings only, that way you don't have to click on every individual ladder to click deconstruct.

Check out the materials overlay (f4). It can help with trying to recover any steel that was used. Just set it to metals and it will show everything on the map that is made of metal.

I would like to apologize for the audio. At some points it gets muddled too much with the game audio. Still working on the settings.

The default to steel as material drives me nuts! To prevent that from happening you can put steel in storage lockers in a room with a locked door. Unlock the door when you want to build with steel and then lock it when done. This prevents the auto switching to steel. You can go one step further and have an auto sweeper ship steel from the refinery directly to the locked room.

I've been enjoying the series. Some suggestions for future games are Rimworld, DotAGE, and Timberborn. Thanks!

The progression of this game is very steady. So far I am enjoying the experience :)

Nice!

Nice!