Video

Exactly how my cord broke. Bad design

hey mate can you show where is crankshaft is located thanks

Just start alloytec up with instant 2000 rpm on the throttle when cold and they won't rattle/grind due to oil reaching right places instantly

This is the greenest reuse of PVC i ever seen. Made a shiddy situation and gave it a re doo. Impressing the co workers is only the begining of this life changing hack. Thanks as I am in a spot and need this shower finished and the stores dont open for 5 more hours, This just saved me alot of time and now I can plan a day of beers tomorrow after all.

Poorly done, why not show it step by step as it's done instead of starting in the middle.

U do realize that u can simply keep it in boiling water and it will become soft enough to be pulled out

Bruh, is that just me or your car is actually on 600,000 kmsssss

That is so cute.

Lil sleeping beauty! 💞😍😴

You forgot to mention an important step… you got to have 2 beer bottles around!

Very helpful mate thanks for taking the time

It’s not the actual oil pump just a worn o ring on the oil pump

Is it really worth it?

Ewwwwwww

Worked great, thanks for the walkthrough.

Had that on my ve 2 Sportswagon

Hey bud Tks for the tip. By far the best way and nice to see you have some experiance in doing it as apart from the f wits yanks posting for adds. Big thumbs up bud.

It is not hight Prasure Pipe, becouse is very easy Elbow , so that we use hard pipe.

Did you find the problem, mines recently just started and sounds louder and little longer

WM sufferings!

pretty stupid

fittings are a few dollars...

Hungry lizard

Very useful thank you

Guido Hatzis learned everything about plumbing from his uncle

Hey mate did you ever find out what made the noise

फारच छान माहिती दिली त आभार.

wtf

Shame no en-suite no outside cooking. Get the swag out

perroni is a great beer

Great explanation. Thanks from Georgia

Do your kms say 679? Or 079?

What's the green stuff called?

Replaced chains, actuators and everything in the end changing the oil pump fixed it.

Its the oil pump.

Rs 10 to 20 k elbow k leay itna glue aur time zaaya krna bewaqoofi hy:)

nice will try .

My VF did that exact same sound and Holden finally found it was the cam Phasers! Had to pull front of motor apart to replace as they were bleeding back and not holding on to oil pressure

Very good vid!!!

You can't have open fires on a real job site you'll get kicked off in a second

So cute! 🥰

Complete waste of time when new fittings are dirt cheap.

Waste of time reusing a fitting. Just cut ,prime , glue.

Cheap fucks it's only 6$ go and buy one

It makes me feel calm somehow ✅💖💟💐😊

I needed a ppvc t . Took an old one, took a microwavable bowl, covered the t with water , set timer for 6 minutes. Removed t from water and twisted pipe piece out with pliers. Put the t back in the water, microwaved for 4 minutes. The other piece of pipe came right out. Took my pocket knife and cleaned out the excess glue from the t. Took an emery board, sanded it out a little, used it. Why all the trouble doing this? 8:00 pm , 30 miles from town. The process took 15 minutes. Couldn't drive to town and back in that length of time.

Use a heat gun

safer method as demo on anoher video is to heat a two inch steel pipe and stick it in the pvc fitting for one mnute or so then remove. You will be able to remove old pvc.

This gives me serious baby fever I'm only 11...

Awesome! I like it! Thanks!