![QuadCamV8](/img/default-banner.jpg)
- 118
- 298 358
QuadCamV8
Registrace 27. 08. 2011
Video
Sequoia on 37s at Prairie City
zhlédnutí 4,2KPřed 3 měsíci
Last time I was here, the rig was on 33s. returning for round 2 on 37s tire pressure was aired down to 15psi suspension and wheel setup: Custom 1" body lift Fronts: bilstein 5100s on 1st notch OME 2885 (2" lift spring) 1" (ratio ends up being 2" lift) daystar strut spacer Total Chaos uca perry parts extended bumpstops overland custom design heimjoint endlinks. Rears: ARB 60200 shocks OME 2862 (...
Sequoia offroad
zhlédnutí 4KPřed 3 měsíci
group run to the trails of Fordyce Creek with the gang on 37s Custom 1" body lift Fronts: bilstein 5100s on 1st notch OME 2885 (2" lift spring) 1" (ratio ends up being 2" lift) daystar strut spacer Total Chaos uca perry parts extended bumpstops overland custom design heimjoint endlinks. Rears: ARB 60200 shocks OME 2862 (2" spring lift) Rancho 38mm coil spacer overland custom design endlinks. Wh...
Sequoia body lift on 37s
zhlédnutí 2,4KPřed 4 měsíci
1" body lift was done to gain some additional clearance for when the tires up-travel. this is a daily and weekend warrior rig on 37s. note, for the rear bolts, front oem length can be used as it is longer than the rear. parts used are listed below with links, thanks for watching and hit that subscribe button! 10"x10"x1" uhmw (Ultra-high-molecular-weight) JOIKIT 2 PCS 10 x 10 x 1 Inch UHMW Sheet...
Toyota Sequoia perry parts bumpstop install
zhlédnutí 233Před 9 měsíci
Toyota Sequoia perry parts bumpstop install
Sequoia shackles and D Ring diy install
zhlédnutí 1,8KPřed 11 měsíci
Sequoia shackles and D Ring diy install
Lexus GS300/GS400/GS430 wheel spacer install
zhlédnutí 456Před rokem
Lexus GS300/GS400/GS430 wheel spacer install
Sequoia total chaos control arms install
zhlédnutí 2,8KPřed rokem
Sequoia total chaos control arms install
Sound evil and smokes like a chimney.
@@My2ndtimearound she smokes on cold starts but still running strong and passes smog at over 400k on the engine surprisingly
Isn't the lexus almost the same as the sequoia? Same engine
Same engine smaller platform and frame
Buy a FORD period !
Such a dumb comment lol
That's hilarious 😂
buy a Ford if you want to break down before you ever even get stuck
Truck looks bitchin but that suspension doesn’t seem to articulate very well, looks stiff. Granted I’m not there in person so this is a very subjective opinion.
@@notacreativehandle I agree it is a bit limited with the down travel. Will be doing a long travel setup soon as this is my first time setting up a 4x4 rig
@@saeturn29 Hell yeah!!!
We both need lockers lol
Seriously fun video...way to go!
Bro thinks he’s driving a manual 🤣 😭
@@DaniG.German883 it helps keep it in the proper gear and works out so far 🤷🏻♂️
this comment is too cringe
Couldve taken some air out of the tires
@@mikellwebb5824 you could've read the description 🤷🏻♂️
uz?
@@bigboy8649 1uz vvti
Yeah center diff lock on it would have walked up that with no drama at all.
@@Hammbone2519 definitely agree with this. I'm gonna have to do a bypass or something to keep it locked incase I have to throw it into reverse or something, just incase I have to change up the driving line
@@saeturn29 what year is your truck? My 03 has a button to lock and once you lock it, it stays locked until you press the button again or shift back to 2wd.
@@Hammbone2519 mine is 01 🥲
Less tire pressure?
Dude can’t drive.
@@4800BMO first time wheeling here, hopefully I got better this time around. Thanks for viewing
@@saeturn29 💯 I’ll keep checking on you.
Open diff life 😮
@@williambreeze2659 locker loading.... ... .... ... .....
Just got me a sc400 recently didnt know u could rip the auto like that
@@jeremiahcastellano1964 welcome to the Z30 platform! it's the same A650E 5sp auto from the GS400 which has the E-shift. I'm going 6sp manual soon though.
1st gen lookin clean bro! Disconnect those sway bars and get a locker. Way more fun
@@OscaRCvideos hell yeah! That's definitely on the to do list!
Nice driving what does your suspension setup look like ?
It for some reason sounds like an American V8 but that's just me listening to the rumble of the engine, I could be wrong. It could just be the exhaust system he has on the car. I'm new to this channel so idk for sure.
Ming lo
@@damienchin4473 🤝🏻
Were you ever in 4lo? Seems like a lack of power
@@vict1036 4hi. I had it in 4lo and center diff locked when I climbed the pyramid and it did it with ease.
What kind of brakes are you running? Stock with upgraded pads and rotors?
Would you recommend this one (rs146) or the other one (rs145) i know this one hangs down lower for bull bar's but if no bull bar in the mix which would you recommend?
I suggest the RS146 which is the ones I'm using. I have seen the rs145 and they angle too high and likely to damage your front bumper in a tugging situation
What’s the actual setup from the headers? Like are there any x pipes etc? Could ya gimme a full run down? Also what headers are they and do you think they’d be a good fit for an LS
@@TM-fx5le the headers are hurricane long tubes (42mm runners to 2.5" merge collector) I customized the exhaust from the headers and back with 2.5" X-Pipe and piping with no resonators, then through 350z hks mufflers that I modified to fit.
exhaust setup?
@@spyrobesity9435 gibson catback
@@saeturn29 with muffler?
@@spyrobesity9435 see my gibson exhaust install for sequoia video. It comes with everything you need
What’s up brother I’m Hmong from sac, I know you’re a mein brother but do you have and idea about the VSC trac and abs lights? It came one after the bilstien 5100s lifting it slightly, It’s hella annoying. I recalibrate and put out in a new yaw sensor but still won’t turn off. 🤦🏻♂️ you have an awesome ass rig! Love it!
@@adamvue8589 my VSC and TRAC light came on before I did the lift. I believe it's the Yaw rate sensor but I don't care for it too much, so I left my traction control unplug to bypass it. The abs still works but no traction control.
How did you manage to get up the pyramid? I tried and couldn’t I’m in your same boats needs lockers and long travel also hmu next time and we can finally link up
@@elijohnson726 had a good spotter. I was able to do it before when I was on 33s. The 37s made it even easier, and yes. Will definitely throw an open invite on the next one over the fb group
Good looking truck but your not doing the sequoia and favors with that driving ability!
Thanks
Bro doesn’t understand how important it is to show the overall view and stance after the install.🤦🏾♂️
Oops 😬 stance shouldn't change much besides camber being corrected as total chaos uniball design is intended for.
So this looks like just 4x4. Not locked dif. Right?
Yes, This was in 4hi majority of the obstacles. No center diff lock engaged and still open diff on the front and rear.
Just ordered a set of the low beam ones, high beam no longer available but still happy about the low beams!
Hell yeah! Mine still somewhere in the garage.. lol
What tires are those and how's the ride quality on them?
Fortune tormenta 37x12.5r17. They ride pretty decent
You have the best LIFTED 1st gen on CZcams
Thanks 😊
Whats your control arm setup all around? Car looks great!
All arms are stock except for front uca, they are figs engineering track spec
The title is exactly what I looked up lol. Good stuff
Thanks! Glad to hear!
You should join our Bay Area / sac off-road group!
That sounds like it would be fun
headlights? I am having a hard time finding ones that fit on the pre-05 version.
They don't make them for pre 05 models. You will have to trim back some of the backing of the sheet metal to make it fit. These are from amazon, Autosaver88
Sounds great! Looking to build mine as well, what kind of mods have you done?
It's a long process as I'm only a one man team lol. But here's the write up and build thread. www.clublexus.com/forums/build-threads/980593-time-attack-sc400.html
You still have stock gears in there?
Stock gears still.
What year Sequoia? You change the gears for the 37s?
01 limited. Stock gears
Hello, I'm definitely trying this on mine, I hope everything comes alright. Thanks.
You got this!
I been watching your videos for a min im from sac to wth 😂 I need a ride along in the SC
The old girl is sounding good brother!
Thanks!
That's some sick off roading. Great content!
🫣
Put the ole girl in 4low and let the trac control help you send power to those wheels
I agree but unfortunately, My atrac doesn't work due to bad yaw rate sensor. So traction control is unplugged. Locking the centerdiff in 4lo still makes a difference tho which I should have done on the frame twister
Truck is looking great brother👌
Air down man!
It was aired down to 15psi already
You got IG?
@bboyjohn04
🔥🔥🔥🔥🔥
🙏🏻🙏🏻🙏🏻
We need to get another run in soon
Hell yeah!
Besides headers thats the best sounding stock 1uz ive ever heard, are they long tubes? It sounds amazing
Yes longtube from Hurricane
where you get the ehaust from?
They're custom. I fabricated everything besides the headers and X pipe
Muffler and tips @@saeturn29