![Isaiah James](/img/default-banner.jpg)
- 5
- 385 300
Isaiah James
Registrace 25. 05. 2020
Adventure, outdoors, cooking, how to and more.
Hilton Los Cabos Beach & Golf Resort - Destination Wedding December 2021
Vacation at Hilton Los Cabos for designation wedding as guest.
zhlédnutí: 2 054
Video
Wild Duck Ragu Bolognese
zhlédnutí 271Před 2 lety
Homemade wild duck ragu bolognese made from wild duck harvested by myself and other local fresh ingredients.
Duck Hunting - 20 MINUTE LIMIT - Quad Shot Caught on Film
zhlédnutí 92Před 2 lety
Duck hunting with my dog, Mando. We got our limit in 20 minutes and shot 4 ducks in one pass. January 2022 - Snohomish, Washington.
Duck Hunting - ALL DRAKE LIMIT - Search for the Spoony
zhlédnutí 121Před 2 lety
All drake solo limit with my dog, Mando. Snohomish, Washington - January 2022.
Easy Fix- GMC/Chevy 2007-2013 Flashing Check Engine/ Stabilitrak/ Traction Control
zhlédnutí 383KPřed 4 lety
Several lights such as check engine flashing , stabilitrak, traction control and rough idling came up all at once. After research I was quickly able to find that it was simply a problem with miss-fires in the cylinders and the other indicators were common byproducts. I simply changed the spark plugs and fixed the problem instantly. Truck runs great, I took it over a mountain pass and back pulli...
Did that that didnt solve the issue so i replaced my coil packs on my gmc acedia 2015 it was a cylinder misfire 1 only other issue can be fuel injectors.
Going through this right now. My first thoughts were I need spark plugs. Either cylinder 7 or 6. Gone try it out and come back to the video. Thank you my guy
This is exactly what's happening to my 2007 chevy tahoe but I changed all the spark plugs plus the wires for the spark plugs still having the same problem 😫
Im having same problem now
Cylinder 7 is infamous for going bad on this engine. The worst eninge ever made
0:02
Hmmm... just got this problem..
GM corporation owes all of us a refund for buying their vehicles
Thanks man, I appreciate the video
Thanks
I’m in need of help!!! I have the same issue, cylinder 1 misfire. I changed all wires and spark plugs and still have the same issue. Anyone else know of any other ways I can fix? I have a 2007 Avalanche 5.3L
Thanks for the video I have a misfire 6 on my Chevy Avalanche scary stuff man
GET TO THE POINTTTTTTT. GEEEZ TO MANY PAUSES, UM's AND UH's.
Great training video. Well done sir!! THANKS.
Mine is p0300 flashes and traction control and turns off right away
Ever ever figure out the problem?
@@-._J I believe it was the ground wire that goes to the engine and battery I forgot but check if the wire heats up touch it if it’s hot replace it
Changed spark plugs and wires and still same issue , any one else have an idea of what it could be
Mine did the same thing. Work for about 600 miles. Now it’s doing it again and it didn’t work the second time… little white smoke on start up sounds like it’s runnin on 4 cylinders and ticking… any suggestions folks?
My 2008 did this exact thing this morning when i left for work. About a mile from home. Lost engine power during this little episode also. Jumped in my car and went on to work and made a day and when i got home i cranked the truck and all the lights are now off. Does this sound like the same issue you was having?
Happened to me about 1 o’clock this morning. Watched your video. Woke up, went to O’Reillys got a spark plug. Number one cylinder was misfiring. Quick easy fix. Thank you.
So thos actually worked?👀..what did plugs have to do with stabilitrak?
Yes
Great video. Looks like you’re improving!
Thanks for this video I’m gonna try it. Hopefully that fix the problem my 07 Chevy suburban. Thanks again great video ez to understand 👍👍
Had this happen yesterday blinking check engine light and service traction control and esc off car was also rough idling engine shaking bad. Changed all 6 spark plugs and my lights went off for now will update in a few weeks or a month
Yes it did thank you very much mine went off yesterday I pulled into an advance they put the code thing on it it said it was admissions so I added some fuel cleaner to it but it did not clear so I'm thinking it is the spark plugs once again thank you or do you have to clear it manually
I have this exact same issue. So glad to see your video and put my mind at ease that I diagnosed it correctly. Thank you!
I just changed mine! Hope it takes care of the issues too
I changed wired and plugs and still same issue
@@grumpyekit usually all stems from the AFM /DOD that's why people do the dod deletes it will save your engine in the long run
Thank God found your video, the exact same thing happen to me, about the same distance but they lights turned off once I got home, but I checked on the computer and it also says a misfire on cylinder 7 same as you and it was pending, so good thing I saw your video cuz I was starting to stress out. Let's see if that fixes my problem.
Great video, hope it helps. Thanks
i have the same exact issue i replaced the spark plugs replaced mass airflow sensor and cleaned throttle body works much better but still getting miss fire im guessing imma have to check for a bad coil
Same thing here so I replaced the coil and still have the misfire so turns out it might be the fuel injector, gonna go ahead and replace all of them tomorrow and we’ll see.
Was it the injector?
@@Goodoltimer no i pulled the fuel rail and all that what ended up fixing the issue was changing out the o rings on the injectors and the seal on the intake manifold the rubber was just old on all of that, also lesson learned get ac delco for your chevy/gmc dont cheap out on autozone parts XD
You have an oil consumption problem which is why your plugs have so much buildup on them. Normally, these plugs will easily go 100k miles without failure and then only the gap begins to widen causing an occasional misfire.
2010 - (100K on it) cylinder #7 -> due to drivers side valve cover pcv valve "rail" defect from factory (smothered plug basically with oil)... I replaced the valve cover with new designed one, replaced all the plugs/wires, new air filter (clean MAF sensor as well), changed oil, cleared codes (battery unhook - (-) neg side for an hour... hooked back up,,, varroooom!! good to go!!...thanks... _DTM
I just had the plugs changed last summer and there is plenty of oil. So I’m not sure why it’s knocking
Mine just did this again but this time the with the flashing engine light and knocking noise
My Silverado just did that, went to Dr CZcams found your video I appreciate you making the video, saved me a lot of time effort. Thank you Sir !
This made my day… “Dr. CZcams” I’ve never thought of it that way before. Thanks. Not only a doctor but a mentor as well…
I have a 07 6.0 Silverado vortec max. Was towing a light load one day. And something gave in the engine bay. All the same lights came on in the dash. I took it to a few mechanic shops, cylinder 7 misfire. They took the top end off and said I had a bad rocker arm. I’m now looking at a 5k motor to drop in it.
You can replace the rocker arm without getting a new motor I did
@@bundywhitmore9671 I’m so glad I’m going this route. I decided to not buy a new motor and do a rebuild. Thank you
I'm going through the same thing but my Inj-B fuse #13 on fuse box keeps burning I changed it drove half a mile as soon as I passed a bump it burned the fuse I try the scanner it said coil #2 #4 #6 #8 I changed those today and it keeps doing the same thing
Congrats! We got married there in 2006. Love that place!
Have a 2010 replaced alternator solved all problems so far 2000 miles no problems
what problems did it solve?
Door locks, locking, unlocking, traction control going off all the time replace the battery cable negative and alternator
I like the quickness of the video! Nice work!
Had the same problem, put the scanner on and it was my catalytic converter
Hello, I recommend the Phoenix Elite from Topdon to you. I am also using it, and I think it is very good. The functions and coverage of the models are very complete. Here is a video of me using this device to reset the engine Oil Light for the 2016 GM Suburban: czcams.com/video/M_4W8pUm6_0/video.html , you can refer to it, maybe it will help you!
A bad wheel hub/wheel bearing will also cause traction control and abs problems. Had this happen a few times.
Changed mine out and the codes didn’t go away, even after clearing them. No engine light, just brake, traction control, and stabilitrak
Awesome tips Brother but I did replace the spark plugs and wires I’m still no solving the problem….
Changed my plugs and still doin the same thing
I also had same problem went to oreillys had them hook up Obd and said was cylinder number 7 so I bought 1 one spark plug boom was fixed the next day replaced other 7 and cables running like a champ now
Hello good videos
I have a gmc sierra 2007 same lights on but it rides good until the light comes on and shift hard when it shifts 1st gear. Do you think it can be the spark plugs? Any idea
I have the same problem, did you find what the problem was?
Same here . Started today
Same make and year, same issues as yours. Runs fine until stabilitrak turns off, shifts hard from 1st to 2nd, then runs fine after that. Only does this after stopping and idling. Anyone get a diagnosis for this yet?
I have a 2008 Silverado exact same issues as yours I change the plugs and wires and it ended up being a lifter was collapsed I even drove it like that for three years with a collapsed lifter taking it easy
I’m still driving my 07 suburban with collapsed lifter so far a month
Spark Plugs? People don't change them things till they are 50k miles past due. Plugs are cheap, but for some reason half the population does no change them till the car barely runs. What they don't realize is for the prior year they got 3 miles less per gallon burned. 30.00 set of plugs cost you 200.00 in extra fuel last year.
30 for plugs I have 16 plugs at 11 to 15 each ! Good for hundred thousand miles
It’s not the spark plugs that would cause this
Yes bad spark plugs can cause a misfire.
My 2009 Tahoe light keep coming on and flashing already changed spark plug on clinker 6 and ignition coil what do I do now to fix it please help
2008 sierra and is doing the exact same. Just changed plugs and wires.
Thx you