Video

After two years, what do you think? I’ve heard a good bit of negatives about it over time

Can I send you a picture of Mimi rear quarter panel for your opinion on repair vs replacing

Your in a fracking race or what

I have a 2004 325ci convertible. Getting the wire routed to the front was not easy as the seat doesn't fold down. I found there is a straight run on the driver's side where the wires went to the CD changer. I could easily get the video cable fished through the rubber grommet from the inside to the back and then pull the video cable through into the car and run it along the door panel up into the dash. There is only a small gap from the radio chamber, but again, it is okay to fish the wire through it. Go from the trunk lid across the back of the convertible storage tray then down to the CD changer location. The channel is just inside of the wheel well bump. I hope to make a video when everything is complete.

😮 Holy crap Amel !!!!!!!

Awesome video! I'm about to tackle an overheating issue in my 2001 Cobra. She has almost 200k miles so am figuring that I go on ahead and replace the heater core while I'm at it!

Forever Black...lasts for a year? 😂

No one changes a throwout bearing unless they just put a new clutch in and the bearing you just replaced is bad from minute one. In my history of owning 7 Mustangs, 5 of them manuals I have in fact had a brand new throwout bearing be defective and noisy. Fortunately, changing a clutch in a Mustang is really easy unless it is a Fox body with welded X-pipe/exhaust and long tubes.

Man this is so awesome. I gotta question though. In the previous video, how did you figure out exactly how far up the strut towers needed to sit? Did you measure off the mustang?

I clean my evaporator great video but that didn't solve my problem of not getting too much are in my vents came to find out the insulation in the back was covering my air duct in the back

Try a electric fan

What are those connector plug things on the cross member?

Thank you for your information:)

Do you have a link for your headlights and the angel eyes too

before you fixed it was it cause the car to back fire or for it to run rich / lean ?

Reset the pcm after 02 sensors replacement Also take off carb and clean it really good. And put zip ties of gas pedal cable inside the truck to bring it up if there is play in the cable. Helps alot.

Hi do i still need a digital sound box, even though i have the harmon kardon amp thanks

That's a t45 or tr3650 trans? Thanks.

Did you have any issues with the sound settings, I just installed mine and there’s no bass at all I’ve tried moving the settings but nothing seems to work I have the Mach sound system and before I got the stereo the sound was great. Not sure if I miss wired something or it’s the just the stereo

do you fix other people cars. i have same car same issue.

Hi Amel, I'm considering purchasing a 2017 5.0 litre V8 Mustang. Do you have any pre-purchase advice to offer, thanks.

Do you have to change the computer or whatever it’s called in it or no

Where did you buy that part? I can't seem to find it anywhere.

Is The little hole on the thermostat supposed to be facing down?

Really comprehensive video so thanks. 2questions. 1. Does the Android system require connection to your phone to play the radio, or does it have a radio built in? 2. My 2003 330 ci E46 has a Harman Kardon system, so do I need the additional amp you mentioned (does it come with this model) as I could not see it on the website? Phillip

Hi new subscriber. do you think this would work on a tan top. trying to make it black for cheap lol

Plastic conduit?

Honestly I have never heard of that brand. I installed Kenwood units in my Mustangs.

Looks great 👍

🔥

Jokes on you both my door panels fell of 2 years ago 😂😂😂

Hey buddy no saw how to remove it let me jump to another video.😅

Interesting. 99-04 Mustangs love vortecs,

I had a pretty obvious leak on my Mustang too but it’s actually coming from the vent. Ford makes a kit to relocate the vent higher and prevent leaks

do you lose volume and skip controls on your wheel

Did you have to connect to a reverse trigger wire on the radio harness?

Thank you for your video this was super helpful!

Is this a vinyl top or fabric?

Can you do a rebuilt fo rme as well on F10.

Love the e video just subscribed

perfect, thank you

You did a great job maintaining this mustang. I was 1 years old when you bought this car

On the light bar installation did you cut the middle plastic to make it fit?

Smooth ... Not over or under engineered like some others I've seen. Props!!! 👏

We’re did get those blacked out kidney grilles bought some for mine and there just not fitting properly

There's a plug n play kit for this now and it handles all the settings n shit so it doesn't go nuclear. Nice install man your attention to detail was impressive

Where did you get the parts? I’ve been looking all over for my 96 grand Marquis

Any chance you can post a pic of your wiring diagram?

What color grey is on that on your car?

Awesome video 👍🏼