Video

What would be the Benefit if getting this over the impact version? You can do everything you can do with this that’s you can with an impact plus more

Could you use a flat-head screw driver?

I appreciate the views from the rear of the pump. I'm replacing mine now and your video was the only one that showed the rear side. Thanks!

after driving to work about 2 days ago, my 2006 nissan altima would not start when it was time to go home , obd port not communicating and all power windows where not working either. i have been trying to figure it out but so far nothing yet. please any ideas on what to do?

Thanks for the amazing tip!!! I just cleared the lines on my wife's Roque. You're right about the blocker that was at the end of the line. It definitely made no sense. After removing it, the line pretty much cleared itself. Thanks again 👍🏾

You really made this look so easy and fast I know I could do the front part but the back is what I’m scared of. Do you not replace your coil packs when changing your spark plugs?

Would it be the same procedure for a 2013 versa @autofixpals

Thank you, you saved my day, even my mechanic didn't know that. Thanks again.

Thank you for your great review

So helpful! Thank you so much!

Excellent video thank you so much indeed and no need to pull the axle out of the transmission 😉

Is the grease different to the outside joints????

You’re the only video that mentions changing the gaskets. I wasn’t going to because nobody in the other vids I’ve watched changed them, but you’ve changed my mind to order the gaskets. Thank you. Just subbed.

GOOD VID

Good job man !! Really helpful

$9.99 at Harbor Freight and will pick them up tomorrow!

WT£???

Awesome help thx Canada

So how can I jump start the clutch

Hey man nice video. Thanks for supplying the schematic. I have an issue you might be able to help me with on my 2007 HHR. My rear driver window only will go down and not up with the switch on the door itself. Nothing happens with the button master switch at all that controls that window. However all other windows work fine on that switch. I went to the junkyard today and replaced the master switch, window regulator and motor and switch on that door. Still the same problem persists. Any advice you can give me on my problem?

Any info on replacing the actual support bearing

Great video, but wish you showed how to remove the connector to the wires. Is that a wrap around holder for the solenoid?

(HELP) I have a 04 Maxima, what if that valve work and I replaced both cam sensors and crank sensor. What can make the car stall? I did new coils and spark plugs.

I just bought a used 2008 nissan xterra, 2 wheel drive. Ive only had it a week, and immediatelly it sometimes difficult starting it makes sounds trying to start but takes 5 - 10 seconds sometimes to finally fully turn on and engine run. But usually if its been running and only recentlly turned off , if i start it soon after it seems to usually start right up. I may be misremembering, but it seems to have more difficulty starting fully if its been turned off for a few hours or overnight. Guy who sold it to me said nothing about it, but i dont trust him at this point, as no way it literally just started happening the day i bought it from him. I had battery tested and its good, only a year and a half old. And i noticed a slight fuel smell today inside the xterra while driving it. Unfortunately i was told by oreillys auto parts when i asked about getting a new fuel filter that this model xterra doesnt have just a simple fuel filter that is easy to access and remove and replace alone, as its instead supposely inside the friggin fuel tank and has to remove the friggin fuel tank and replace whole fuel assembly and buy and whole new fuel assembly to replace fuel filter. Which is nearly $400 for just the part! What batshoot craxy dumb design instead of jjust having fuel filter outside fuel tank easy to access and replace like some vehicles.. And this xterra has a built in alarm system connected to a chip in the key, apparently. When locking and leaving vehicle apparently after getting a certain distance from vehicle thealarm automatically arms. Suddenly today when i drove to auto store and turned engine off and removed key, immediatley as i opened door to exit the vehicle the alarm suddenly went on making alarm noises for a minute. Had no idea how to turn it off or why it suddenly started alarming as i was still in vehicle with the key in my hand. It at least stopped alarming sound after a minute. Just concerned as it shouldnt do that and have no idea why it did or if its going to again and how to stop it.

What would cause my 2013 Nissan Juke to throw the same code?

M14 x1.5

It's a partial change, total capacity? around 9.8ltr, changed? 4ltr... To change all? need to run a flush on CVT. Or? run this proceedure 3 times with 20 to 30 miles between changes. Ending up with fluid as new as possible, and do it every 25,000miles, cheaper than a new trans And remember, Nissan have not approved NS-3 for use in CVT's prior to 2013, follow the sticker inside your car hood..

Not necessary just remove the bracket bolted to the block.. 3 13mm bolts and axle out of the way

Obrigado pelo vídeo 👏👏👏👏

From 81 year old guy been designing hose products for a very very long time …1969 at Weatherhead Engineering..(we designed and supplied power steering ,AC AND brake hose for Ford ,GM,CHRYSLER , American MOTORS ,Volkswagon ) Do not ever crimp a rubber hose like that !!!..unless you are ready to replace the hose… many times you will crack the inner tube in the hose… I know …?I have done it!!!!! Old guy in north Ohio!!

I have a 2013 nissan sentra and my transmission went bad i can get it fixed for 2500$ canadien $$ but is it worth fixing its at 140km

Thanks for your help!

We did this the issue is I have water under my carpet sloshing around so now we are removing the interior and carpet to get the water out. My carpet has mold all over it 😭

Can i clean the trotlle without the relearn gadget u have? Will taking the battery cable do it? I did it before and it mess up the idle so i wanted to know if i could do the cleaning of the throttle body and dont need a gadget to relearn it

This car is built like shit man wtff

Thanks Bro! Great idea! Worked like a charm! Very much appreciate you and this Video

my issue with warranty is you now have a broken tool to dispose which impacts the environment. I believe in buy better, buy less.

This worked really good idea

Thanks a lot 👍

Hi Dear, I am delighted to watching your video regarding sunroof leak! It was so useful and practically done that, I have fixed my similar problem in just 30 minutes!! My one is Nissan X Trail 2015. Thanks a TON👍

Hello.in case there is no power in the white wire what could be the problem?

That’s not a 2013 tho

Where’s all the links for the solenoid? I was only able to find the valve assy-sol

Damn good video. Very professional.

Beat video on CZcams on how to change the belt. Thank you for saving me $400 bucks!

Thank you for all of your help! I love how you showed every step in your video! My 2015 Rogue was leaking because of the drains being blocked but I followed your video and the water is flowing freely once again!!

This is *exactly* what I was looking for, I was confused about the notches and the cross-hatching. I can't believe you answered my exact question. Any idea what the notches are for? Just to confuse us?

Thanks for the video, are you still doing videos

You take the whole sub frame off M