Video

Because Kremlin uses a number 5 JIC fitting, And the Tritech uses a standard quarter inch fitting, you need to get one of the adapters that I show here to connect the two Part number 2405-5-4

Spend less time handling doors by spraying both sides at once. Recoat in an hour or two since there's no risk of marking up the doors an a drying rack. You don't need to spend a lot of money for hanging equipment!

totalfinishingsupplies.com/products/360-true-light

How to lighten red oak cabinets with colors and glazes. #renner #fauxfinish Check out Fine Finish Supply in Texas for supplies.

Vinyl sealer primer or water based primer - pros and cons.

Refinishing Red Birch Cabinets with Toner Stain - Day 2 Continued, Day 3 Installation

Refinishing Red Birch Kitchen - Day 2 / Renner stain toner / Renner clear coat

Refinishing Red Birch Cabinets - Day 1 / Renner stain toner / Renner Clear Coat

Managing overspray when spraying cabinet doors

This video is about mixing up 2k waterborne Renner products and how to know how much to mix up per batch. I use waterborne Renner 688 topcoat and 643 primer. I use them as 2k so I need to weigh out the product and then add the correct catalyst by weight. Topcoats I figure 2 oz. Per side per coat and primer around 3 oz. I figure a gallon or so of primer and topcoat for the cabinet boxes. This eq...

How to avoid these scratches in cabinet faces on corner cabinets.

Renner 688 catalyzed 15 percent Reduced with retardant at 5% Cat X gun with 2 HP portable compressor 1.3 needle and PPS cup. Set cup pressure to 3 -4 psi Triggered air around 20 or 25 psi. 28 ML cup gets a little heavy. Use the 13 ML cup for less fatigue

Thanks for watching! If you've found my videos helpful, please consider supporting - (see link in bio) - buymeacoffee.com/raymondw Thank you!

Apollo 7700 gun works great with turbine. Get at least a 5 stage turbine for water based coatings. This gun can be used with compressed air as well but needs a large compressor and at least 11 - 13 CFM C A Technologies Feline LCFM gun needs only 6 CFM. Can be used with a 2 HP portable compressor. This is a great little sprayer for job site spraying Cat X gun needs 13.5 CFM at 29 PSI. This requi...

ICRO Waterborne Paints - Review and Tips for Spraying

Graco G15 / And My Favorite 2K Renner Paints

Some Tips for spraying Renner waterborne paints with Apollo 7700 HVLP. See description for more...

Airless / air assisted airless - How to spray waterborne finish - Tritech T5 / Wagner gm4700

How to clean spray gun with an ultrasonic cleaner - Apollo Sprayer

Installing Shaker drawer fronts with Kolby Korners and adding soft-close adapters

How to clean the air assisted airless spray gun. Wagner GM 4700.

Renner C005 1k with Apollo 7700

Using the Festool Inspection Light When Sanding Cabinet Doors

Sanding Primer On Cabinet Doors

Convert Tritech Airless to Air Assisted Airless with Wagner GM4700.

How To Eliminate Bridging Painting Cabinet Doors with Milesi Paint and Airless Sprayer