How-to Install Footpegs on KTM New Style Chassis

Jeff Slavens demonstrates installing footpegs on the new style KTM chassis.
The footpegs used in this video are Stainless Steel Carapaks pegs:
slavensracing.com/shop/stainl...

[@boployhar294]

Just a heads upbthe Carapaks pegs dont have a built in stop so they will ruin your kickstand spring bolt and smash into your frame on the right side. Not to mention, the set i got were not even close to the same from one side to the other.

[@slaverace1]

Hello:
We have not encountered the issues you have described or had customer complaints and I have many miles on my Carapak pegs. If you are not happy with the pegs, give us a call and we will sort it out.

[@rickvonderchek6898]

Can you do a video of how you grind the points down I just got set from you . I like to dull them down so there not so sharp thanks

[@slaverace1]

Hello
No problem. I’ll add it to the queue.

[@rickvonderchek6898]

@@slaverace1 thank you

[@KooLaidblue]

I'm curious to know what brand cutters those were lol. They looked vicious!

[@slaverace1]

Dewalt

[@tontonn9995]

Does the 2024 chassis require different pegs than the previous 2013-23? Can I use my Fastway 2022 pegs on a 2024 chassis?

[@slaverace1]

Yes, all new. They will not transfer over, sorry.

[@KooLaidblue]

So I bought 24 pegs hoping to install them on my 20 and they installed. However the pivot angle is different between the two and my toes were pointed downward about 1" lower than before. By going the other way around I'm certain your toes would need pointed upward 1" higher. Both ways definitely not flat.

[@robertm7717]

Hi I actually put the cotter pin on the bottom.. if the cotter pin ever loses I figured you could lose the peg pin ..
why do you put the cotter pin on the top???

[@slaverace1]

KTMs come that way from the factory. The left side must be installed that way or the pin hits the kickstand and doesn’t allow it to be fully in the down position. I just inspect the cotter pin frequently. Part of my ride prep.

[@robertm7717]

Never noticed that.. I’ll swap it around on my 24 tx300 24 fx350 also need a fan for the Fx350 it over heats in tight single track, should of bought the FE

[@callumodonnell2181]

I’m 6ft4, which position do you recommend for the peg height/distance? Thanks

[@slaverace1]

I use Carapak pegs, 10mm back, 5mm down.

[@callumodonnell2181]

Thanks