Salamat ani sir.. Problema ko sa ako xtrail 2004 kron d ga start. Before ani, mo start sya then pagpalong mga 1 hour ayha pa mo start balik pero dili gakapalong makina..
@@felsamlopez dili mapalong makina pag naka start sir. Pero kron nisobra nag adlaw di na ga start. Gipa check nako, wala daw kurente sa engine gagawas pero okay ang fuel pump ug starter. Duda sila crankshaft ug camshaft kaso walay scanner magamit sir mao wala pod nako papulihi
@@benmcblowallaroundyou7644 gitan-aw pud nila ang injector pulse nya sir? Bisan wala kay scanner ana sir, bsta naa lang kay multimeter. Para mabal-an kung may fluctuation ang camshaft ug crankshaft sensor
Kung replacement lang ni imo gipa-ilis dili ni siya magdugay labi na og long drive mohagtos dayon..parehas ni sa ako-a,gi-ilisan naku og genuine lang jud..pero okay ni imo channel migo!
Thats not immobilizer problem, it's accelerator pedal sensor, try to read the live data from the scanner. Crank but no start? Right? If no spark and no pulse of injector, that's the crankshaft or camshaft sensor.
if all the fuses are okay, test the ecu input to see if there is battery voltage (positive and negative) if the ecu has battery voltage, it is possible that the ecu is faulty
Sa na experience ko na ganyan sa xtrail sir, yung throttle relay nya pag umiinit namamatay ang makina. Try mo muna palitan sir,. Pag ganun parin, pa scann mo na sir, para malaman kung saan gung saktong sira
i 've changed cam and crank sensor,maf,throttle and pedal sensor,and new fuel pump..my t30 xtrail still not running,it starts but only for few seconds then engine died.. i tried start with pressing pedal but car has no acceleration.. any idea whats wrong with my xtrail?
Wow so many parts you replaced, Do you have a scanner? Put the scanner to the system and calibrate(correct position) the pedal position sensor. That's the only fault for your xtrail. Because even if the pedal sensor is new, the voltage from the pedal sensor is not matched to ECM standard reading.
@@Rreeve87 try go to read data stream or live data stream to your obd reader, read the voltage from the pedal position sensor, set until you get the right output voltage from the pedal position sensor.
Sir, nag DIY ko sa akong xtrail. Gilimpyohan nako ang throttle body gamit ang throtlle body spray. Ako gyud gitangtang ang throttle body. Nisaka man nuon sa 2000 rpm ang minor nya unya aso iyang exhause manifold. Dili kaha naay hungaw sa gasket?
Walay hungaw ang gasket ana sir, ipa reset lang na ang throttle position sensor sa scanner, maulian na sya. Ana jud na basta limpyohan ang throttle body sa xtrail.
Master..tanong ko lng..saan makikita yung VIN number ng xtrail na yan? Kc hinanap ko n sa ibabaw ng dashboard at s ilalim ng passenger seat wla pa din? Nkakapagtaka kc...salamat master
Hello sir, sorry natagal ako naka reply, nakita mo na ba ang VIN sir? Ang pagkakaalam ko sir nasa right side sya banda, maytakip kasi yan sya nakalinya sa plastic ng wiper.
Sa DC mo i set ang analog multimeter sir. Din remove the socket sir, tapus may 5v positive dyan at 12v negative, yung isa na walang voltage sir, dyan ka mag test. Ibalik mo ang socket sa camshaft position sensor. Sa likod nang wire sir, dun mo ilagay ang test prove na negative, tpus ang positive prove sa positive battery. Tpus manually turn the crankshaft sir.
Mi xtrail es 2005 y no manda chispa ni pulso alguna sugerencia solo da marcha
Okay kaayu .....
Bay parehas na SA akong nissan , Peru nailisin nako crankshop sensor camshop dili pagud mo andar
..
Hello sir, sorry dugay ko kareply, kamusta na karun imung nissan?
Meu carro não está lancar corrente nas bobinas mais troquei sensor mais ainda continua nao lançando corrente nas bobinas qual ser o problema?
Hello friend, can you translate in english?
I have lean a lot thanks keep it up
Thank you 😊
Salamat Bro
Salamat ani sir.. Problema ko sa ako xtrail 2004 kron d ga start.
Before ani, mo start sya then pagpalong mga 1 hour ayha pa mo start balik pero dili gakapalong makina..
Dili mapalong ang makina sir?
@@felsamlopez dili mapalong makina pag naka start sir.
Pero kron nisobra nag adlaw di na ga start. Gipa check nako, wala daw kurente sa engine gagawas pero okay ang fuel pump ug starter. Duda sila crankshaft ug camshaft kaso walay scanner magamit sir mao wala pod nako papulihi
@@benmcblowallaroundyou7644 gitan-aw pud nila ang injector pulse nya sir? Bisan wala kay scanner ana sir, bsta naa lang kay multimeter. Para mabal-an kung may fluctuation ang camshaft ug crankshaft sensor
@@felsamlopez naa ko multimeter sir.. ako testingan ugma.. salamat kaayo sir.. dool ra unta ka dri misamis oriental ba..
@@benmcblowallaroundyou7644 hehe kung duol lang ko dra sir, niadto nako dra
Kung replacement lang ni imo gipa-ilis dili ni siya magdugay labi na og long drive mohagtos dayon..parehas ni sa ako-a,gi-ilisan naku og genuine lang jud..pero okay ni imo channel migo!
Mine seems the same. Garage seems to think it's a immobiliser issue. Trouble is I have no dashboard lights on and no fault codes. Any ideas
Thats not immobilizer problem, it's accelerator pedal sensor, try to read the live data from the scanner.
Crank but no start? Right?
If no spark and no pulse of injector, that's the crankshaft or camshaft sensor.
Nissan xtrail nothing from diagonastic plug no communication from diagnostic port what could be possible cause ...and all fuses are ok
if all the fuses are okay, test the ecu input to see if there is battery voltage (positive and negative) if the ecu has battery voltage, it is possible that the ecu is faulty
i have xtrail t30 seems to have spark and fuel considering replacing crank and cam sensors
sorry for taking so long to reply. how is your car now sir? Is there anything else I can help with?
@@felsamlopez it was fuel pump relay would turn pump on but after one key cycle would be nothing
boss patulong po, yong xtrail namin pag mainit na ung makina mamatay sha taz hindi mastart hanggang sa lumamig uli tsaka sha mastart
Sa na experience ko na ganyan sa xtrail sir, yung throttle relay nya pag umiinit namamatay ang makina. Try mo muna palitan sir,. Pag ganun parin, pa scann mo na sir, para malaman kung saan gung saktong sira
sir ang akong xtrail kay mo andar man dayon pag naa na sa byahe mukalit lang ug ka palong ang engine mabudlayan siya
Sorry dugay ko kareply, kamusta na karun ang xtrail sir?
i 've changed cam and crank sensor,maf,throttle and pedal sensor,and new fuel pump..my t30 xtrail still not running,it starts but only for few seconds then engine died.. i tried start with pressing pedal but car has no acceleration.. any idea whats wrong with my xtrail?
Wow so many parts you replaced,
Do you have a scanner? Put the scanner to the system and calibrate(correct position) the pedal position sensor. That's the only fault for your xtrail. Because even if the pedal sensor is new, the voltage from the pedal sensor is not matched to ECM standard reading.
By doing calibration, go to the live data stream from the scanner and read the voltage of the pedal sensor.
@@felsamlopez i do have an obd dongle but it does not have app features for calibrating pedal ..only able to read fault codes and reset
@@Rreeve87 try go to read data stream or live data stream to your obd reader, read the voltage from the pedal position sensor, set until you get the right output voltage from the pedal position sensor.
@@felsamlopez can u make a viceo tutorial on how to read the voltage for xtrail?im not good with this readings
Sir, nag DIY ko sa akong xtrail. Gilimpyohan nako ang throttle body gamit ang throtlle body spray. Ako gyud gitangtang ang throttle body. Nisaka man nuon sa 2000 rpm ang minor nya unya aso iyang exhause manifold. Dili kaha naay hungaw sa gasket?
Walay hungaw ang gasket ana sir, ipa reset lang na ang throttle position sensor sa scanner, maulian na sya. Ana jud na basta limpyohan ang throttle body sa xtrail.
taga cebu ka sir? ga problema kos akong nissan x trail una murag naay hungaw sa exhaust niya perte sabaa, karon di na muandar
Taga GenSan ko, mag cranking pa ba japon sya?
mu crank ra sya sir, pero di gyud sya ka andar
@@monnalizaalcazar4044 na scan na nah sya? Gi try nimo ug buhat kanang naa sa video?
Ohms ba gmit pag check nyn?
Master..tanong ko lng..saan makikita yung VIN number ng xtrail na yan? Kc hinanap ko n sa ibabaw ng dashboard at s ilalim ng passenger seat wla pa din? Nkakapagtaka kc...salamat master
Hello sir, sorry natagal ako naka reply, nakita mo na ba ang VIN sir?
Ang pagkakaalam ko sir nasa right side sya banda, maytakip kasi yan sya nakalinya sa plastic ng wiper.
@@felsamlopez salamat master...tatlong relay napalitan kasama na ang main relay..
@@mervinpanlilio3437 bakit sir? Ano problema? Hehe
u1001 lang ang lumabas sa scanner, ayaw na nyang umandar.
Gud am bossing unsay deprensya sa nissan xtrail dli mo redondo? Salamat
Sa pals ba mag llagay para malaman kng ok ang camshaft sensor
Sa DC sir
Location bay..
mag tan aw ko pes para daghan tag view😅
Maayong buntag mga bay unsa may problima sa nissan xtrail namamay mga bay
Unsa to sir?
Pano check ng camsensor may navara kme na ayw din umandar ang code nya P0340 camshaft sensor
Sa DC mo i set ang analog multimeter sir. Din remove the socket sir, tapus may 5v positive dyan at 12v negative, yung isa na walang voltage sir, dyan ka mag test. Ibalik mo ang socket sa camshaft position sensor. Sa likod nang wire sir, dun mo ilagay ang test prove na negative, tpus ang positive prove sa positive battery. Tpus manually turn the crankshaft sir.
@@felsamlopez Good afternoon lodz. Aling pin sa ECU ang nag supply ng 5V sa camshaft sensor? May ECU pinout diagram ka ba?
@@jericomalalad2513 Hello po sir, sorry ngayon lang ako naka reply, Pero sorry po sir wala po akong pinout ng ECU ng xtrail
How much ohm for the good one?
No ohms required sir, you just need a continuity (on/off) from the sensor if you turn the crankshaft pulley.
Are you located in Davao?
GenSan po ako
I have same problem on my xtrail t30 2006, how to contact you or bring my car to you
I am located in Gensan, which is far from your location. You can find other shops that are near in your area.
magkno yung crank shaft sensor
Nag sure po kung magkano sa ibang store
Sa Nisway po ay 3.8K yung genuine, replacement 1.8K
bat yung sa akin. ganyan din issue, pinalitan ko camshaft sensor ayaw pa din umandar.
Camshaft and crankshaft napalitan nah? Na scann na ba yan?
Natest mo ba lahat nang nasa video? Or nagpalit ka kaagad nang sensor?
Boss ask lang ko kung unsay problema sa Nissan xtrail na mo kalit lang palung inig mag dagan tana mapansin
Pwd nako mabal-an sir? kung unsa ang engine performance nya bago mapalong ug pag start napud nya balik
@@felsamlopez mo start sya sir then taod2 ma palong Ra tapos dugay na mo start ug balik
@@felsamlopez mga 20 mins adiser mo balik ug start napud sir
@@yldeemacarayan8441 ga Check Engine ba sya sir?
@@felsamlopez ou sir
gumana jud pes.😉
Hahahaha
Sir, pwede mangutana? Unsay kalahian sa crankshaft ug camshaft?
Pag sa xtrail same lang po sila. Pwde mo sila ipalit sa isat isa.
Salamat kaayo sir. Pwede pod isa ra sa ilang duha ang ilisdan?
brighta uy
😏😏😏 ana mana