So once it has completed setup, what is a considered a "normal" display on the outside unit LCD? Mine scrolls through the addresses over and over again, but seems to be working fine. The only concern I have is that the target temp is often overshot in one room when the other two larger rooms are still running.
I'm having a communication error with one indoor unit and the fjm here. Is there a way to re address the system like on startup? I checked the continuity of the wires and receimped the termination but still getting the error.
I Started a pipe check with no refrigerant in the lines, would that mess up the compressor or anything? Getting a pipe check error code . Did a reset of outdoor unit. Checked pipes, found one minor kink that I rounded out. Still getting error code
Hello.. I have a challenge with One FJM system with 3 indoor units one of the units doesn't heat effectively and at some point cuts the fan [during heating mode]
Thank you so much, this is so much clearer than the manual
You're doing God's work...currently out of town, boss abandoned me and said good luck. Thanks to you I can have some semblance of hope.
So once it has completed setup, what is a considered a "normal" display on the outside unit LCD? Mine scrolls through the addresses over and over again, but seems to be working fine. The only concern I have is that the target temp is often overshot in one room when the other two larger rooms are still running.
Do you have a suggestion if the k1 button doesn't do anything
I'm having a communication error with one indoor unit and the fjm here. Is there a way to re address the system like on startup? I checked the continuity of the wires and receimped the termination but still getting the error.
Thank you top top
I Started a pipe check with no refrigerant in the lines, would that mess up the compressor or anything? Getting a pipe check error code . Did a reset of outdoor unit. Checked pipes, found one minor kink that I rounded out. Still getting error code
We are having a problem with the modbus cards and getting the outdoor units to talk to our BMS system
So much better than Samsung tech support
How long does K1 take to kick
To tentando configurar o meu mais a Seg maquina não daí o f2
Quantas unidades Evaporador
Hola amigos , debo agregar una unidad evaporadora al sistema , cómo es el procedimiento!
My unit got to that section at 1:32 but it displayed the T1oT and didn’t switch to flash the addresses. Any help?
It happened for me as well. I just pushed the k1 button again and it started doing it.
Solution E2 02?
Samsung vrf ac how to set auto address and test mode
2 time k2 presh
Hello.. I have a challenge with One FJM system with 3 indoor units one of the units doesn't heat effectively and at some point cuts the fan [during heating mode]
What model is your s? On cool mode with all 3 indoor unit on what is the max frequency of te compressor! Thanks
what did you find out the issue was causing this?
My Samsung is showing U.P blinking. Dont know what that means
idk what it means but it pisses me off