First Dyno Pull - 70cc Minarelli Vertical Motorized Bike
Vložit
- čas přidán 27. 10. 2020
- Smolikperformance.com
70cc Racing Minarelli Vertical
7.90HP @ 7250rpm
5.73ftlbs @ 7000 rpm
First pull with an untuned 19mm phbg. It was so lean I had to run the whole pull with the choke on. Still nearly 8hp! That means it only gets better from here. With my usual vm20 and a good tune, I'm shooting for 10hp.
Ryan checking out the Dyno, ggz fellas👽👍
dang, that sounds great.
I need one of these for sure sounds like she had lots of power
Check out my selection at Smolikperformance.com
Sweet 🔥🔥🔥
My baby
Kinda cool b one of the first to get dyno
Frikkin right!!! My motors being build now, finally graduated to the billet case. I’d love to see him hook it up before he sends it off!!
How much u pay to ship it? Or are you local to him?
That's fuckin' sick. I want my shit to run like that
Thats a minarelli, dont use chinadolls
Does VM18 work I have someone interested in the top end, also is there any pipes that come with a 48mm flange, he doesn't want to weld.
Yes vm18 will work with my adapter I sell. Any pipe will need to be modified
Is that a DS80 pipe?
Could I ask what idle and main jet you started with, building a similar project. Many thanks
Badd ass
why don't you put a big head nozzle in instead
What was the torque number? Gotta love a dyno!
5.73 ftlbs
@@smolikperformance3867 Right on!
How much hp did it make
7.9hp
Bike sounds good wonder what the screen said ???????¿????????????????????????
Results are in the description
@@smolikperformance3867 oops sorry 😐 ✌️✌️
Ethan, if I order the vm20 and jets right now could u hook it up before u send it out? It may not be wise seeings it won’t be broke in. If not, you can bet ur a** I’m sending it back before winters over.
Send me a message on fb
tighten the chain.. I swear it was lagged a bit I keep watching it over and over...
Theres deflection of the steel in the mounts and frame. No matter how much its tightened the power pulls it back
What minarelli cylinder is that.
70cc
Unmarked 70cc 🤙
Based on my limited knowledge, the pipe isn't optimal for the engine. Peaks at seven, revs to eleven.
For peak HP correct it is not optimal. However for our single speed direct drive application it's closer to ideal. We ideally want the peak hp in the upper middle of the rpm range with a very very shallow bell curve to evenly distribute the power all the way to slight overrev.
@@smolikperformance3867 broad curve for the single speed. Got it. 80cc MX pipes close to optimal?
@@marthamryglod291 no. Most mx pipes are too peaky. Best pipes that I prefer are 70cc supermotard pipes. Yasuni R2 gives a great curve
@@smolikperformance3867 awesome thanks 👍 I appreciate your research