HSRP (Hot Standby Router Protocol) Configuration In Packettracer | Networking Academy |

The Hot Standby Router Protocol (HSRP) is an IP routing redundancy protocol designed to allow for transparent failover at the first-hop IP router. HSRP provides high network availability, because it routes IP traffic from hosts on networks without relying on the availability of any single router.
Background Music Credits: Unknown - SergePavkinMusic
#Networking #NetworkAcademy #Academy #CCNA #CCNP #CCIE #Cisco #NetworkeNgineers #Ciscopackettracer #PacketTracer #CLICommands
#Basiccommands #CiscoIOSCommands #DHCP #DHCPConfiguration #Packetrtracer #CiscoRouter #CiscoServer #PacketTracer #CCNA #CCNP #Ciscocommands #Network #Codings #hsrp #vrrp #hotstandby

[@NetworkingAcademy1]

If you have successfully configured the HSRP protocol, Mention it in the comment section. Thank you NA Family ❤❤❤

[@mautresim]

Thank you!

[@NetworkingAcademy1]

Welcome

[@arnaudentertainer]

Wow it have been configured successfully
Thank you!!!

[@NetworkingAcademy1]

Glad it helped, Thank you for watching our contents

[@arnaudentertainer]

@@NetworkingAcademy1 You are welcome on:
@arnaudtv1

[@jabeerwrold768]

Thank you this video very helpful for me ☺️

[@NetworkingAcademy1]

Glad it was helpful!

[@mdjunaidgaming4590]

very nice explain

[@NetworkingAcademy1]

Keep watching

[@nissay4168]

This video cleared all my doubt, thanks NA.

[@NetworkingAcademy1]

Glad it helped

[@vaibhavmorepatil2895]

What is the command for decrement priority value if destinations port was down state that's time for path change?

[@NetworkingAcademy1]

If the primary router fails, the protocol will automatically connect to the router assigned the next-highest priority.
------------------------------------------------------------------------------
(Config)#Int Gig 0/0
(Config)#Standby 1 priority 120.
Illustration for above configuration:
(Config)#Standby ___ (any group number) | priority ____ (Value that you need to assign).
-----------------------------------------------------------------------------
But i think to change path, you need to increase the next priority level for that path.