INSTALLING GAUGES AND GAUGE POD ON MY TURBO BRZ!!!
Vložit
- čas přidán 5. 03. 2023
- We installed these new AEM Gauges on my TurboCharged FRS/BRZ to complete the look of the interior and build! I went over how to wire and install all the gauges and sensors such as Oil pressure, boost, and Air fuel ratio! Hope you guys enjoyed todays video!
Instagram: @ThatManDerek
Bump idle to 1k. Rescale maf and map sensors. Will take care of idle drop. If that doesn’t work make sure intake valve is clean.
If you get stuck placing the oil pressure sensor on another build you can get a 1/8 npt tap (an female x 1/8 npt x an male) and add it to an oil cooler line at the sandwich plate end.
aye bro putting same gauges in my car what fuses do you put in addafuse?
You should be placing your AFR o2 sensor at least 36 from the exhaust ports to make sure you get accurate readings and dont burn the sensor -- according to AEM instructions
i would check out gerald just projects for frs/brz/86 they make really good stuff for gauges and just plugs in to the obd2 port
did you have to disconnect the battery to prevent the airbag on the A-pillar from triggering ?
Check your MAF sensor.
What 3 hole gauge pod did you use for your gauges?
ayy its andrew again i just got an mr2
Try changing the spring
I don’t know where to put my oil pressure sensor. My oil line is running to my turbo and my sandwich plate is used for my oil cooler :(
Wait why title say BRZ if it FRS 🤨
Put some carbon 3 piece wheels or carbon bits
1st