Monoprice Cadet (Weedo Tina 2) | Headbed and Light

The heatbed is non regulated. I connect it with a simple DC/DC converter to the mainboard. If the voltage out from the DC/DC converter is adjusted to 7 Volt, the heatbed has around 50 degrees (depend of the ambiente temperature)
I done this some time ago, because I use the printer often on the way. Without the bed, I had often warping (too cold on the way), with the headbed its much better.
The headbed 10x10 was from bangood. I don't know if this is still available.
The magnetic plate I replaced with a metal one (with 3dlac)
Now its a very cool little printer :-)

[@AL3X36000]

Awesome work, can you provide more infos?

[@alnis111]

ABS filament?

[@CedricJRC]

Nice ! how do you connect your light ?

[@AL3X36000]

Hey, I'm currently working on a mod to connect a simple led strip behind the X carriage where you can find some "easy" 12v :)

[@destinationretro5858]

@@AL3X36000 did you ever find out where an "Easy" 12v is?