It’s always worth asking my spec said P clips but the guys there said to use plastic ties. I know all the centres are meant to follow the same rules but it doesn’t seem they do all depends on the centre I had to dismantle my rig after some centres don’t want you to.
I remember I had to do P clips, was a pain in the butt with trying to hold the nuts at the back, think I only ended up doing them finger tight at the start and then tightened them at the end when I knew I was ok for time... My centre wanted to keep it as is so it would be checked and assessed after I had finished.
Someone needs to make an AM2s example rig
Well it’s definitely not the plastic cable ties
It’s always worth asking my spec said P clips but the guys there said to use plastic ties.
I know all the centres are meant to follow the same rules but it doesn’t seem they do all depends on the centre I had to dismantle my rig after some centres don’t want you to.
I remember I had to do P clips, was a pain in the butt with trying to hold the nuts at the back, think I only ended up doing them finger tight at the start and then tightened them at the end when I knew I was ok for time... My centre wanted to keep it as is so it would be checked and assessed after I had finished.
Answer?
Nuts and bolts 👍🏻
@@GSHElectrical
Logical 😳
Does FP200 go in band 1 or 2 of dado trunking?
It will be detailed in the specification/job sheet 👍🏻
This is my Last ever comment ,
😮
until the next one :))