Jeep Thermostat - Diagnose and Replace - Jeep WK2 -(P0128 error code)

Sdílet
Vložit
  • čas přidán 27. 08. 2024
  • Check engine light and P0128 error code, the thermostat is not opening/closing properly
    Thermostat: amzn.to/3HzhuOr
    Mopar 50/50 Fluid: amzn.to/43KrDkR
    Fancy Funnel: amzn.to/3HA0WpI
    My Funnel: amzn.to/3jCuNWn
    Fastener Removal tool: amzn.to/3vD7qzV
    Code Reader 1: amzn.to/3Xl8C5b
    Code Reader 2: amzn.to/40wikUL
    Code Reader 3: amzn.to/3jrzzpT
    Code Reader 4: amzn.to/3HVZsrc
    Hood support Struts: amzn.to/3NQtDT0
    Torx Bit Set: amzn.to/3ho3lqQ
    Mechanic's Screwdriver Set: amzn.to/3JXk2ph
    Multimeter: amzn.to/3wUf48e
    Socket set: amzn.to/40vYvwX
    Socket drive extension: amzn.to/40tg6FR
    Steps:
    - [ ] Check engine light film, p128 engine code, when weather cold
    - [ ] Revised part
    - [ ] Code scanner film and clear, it battery off 10 mins
    - [ ] Trash bay on engine to funnel to clean container
    - [ ] Deep under car and cardboard
    - [ ] GoPro
    - [ ] Check hose temps and pressure
    - [ ] Cover off
    - [ ] Grease stubs
    - [ ] Breather tube off
    - [ ] Wire harness off
    - [ ] Air temp sensor
    - [ ] 8mm loosen clamp
    - [ ] Breather hose off
    - [ ] Remove air box and intake
    - [ ] Square pan and towel
    - [ ] Remove hose clamp and lift hose up or dump fluid
    - [ ] Loosen cap slowly
    - [ ] 10mm nuts on thermostat, 9 ft lbs
    - [ ] Seal glide or die lyric grease on seal
    - [ ] Install thermostat to hose now
    - [ ] Anti sense on threads
    - [ ] Clean out inside hose
    - [ ] Remove bleeder with large flat head
    - [ ] Add grease to it
    - [ ] Add bleeder loosely after coolant comes out
    - [ ] Fill mix coolant to radiator cap, with funnel and let us sit and keep bleeding it
    - [ ] When bubbles stop, tighten bleeder cap
    - [ ] Clean area and compressed air off hoses
    - [ ] Air intake back on
    - [ ] Get engine hot and check coolant levels, heater to max heat, keep eye on funnel
    - [ ] Check lower and upper hose are same temperature
    - [ ] Squeeze upper hose and look for air bubbles in filler area
    P0128 P 0128 P128 P 128
    As an Amazon Associate, I earn from qualifying purchases. But it will cost you nothing different.

Komentáře • 7