Ultra Pitch Video Installation Guide for Numark PT01 Scratch
Vložit
- čas přidán 6. 06. 2018
- This Ultra Pitch Kit works flawless tested on a Numark PT01 Scratch with Start/Stop Mod. It should also work on any other Numark PT01 but hasn't been tested now.
It comes with a solderless easy to install kit.
You can buy it at our Online Shop: portablismgear.com/ultra-pitc...
The original speed controll of your portable turntable (33/45/78) will persist.
All three speeds are down-regulatable.
33 RPM down to 0 RPM
45 RPM down to about 15 RPM
78 RPM down to about 50 RPM
Shout Out to RADIKARL for this one.
Mine rocks! thanks for the ease of installation. :)
i guess I am pretty randomly asking but does anyone know a good place to watch new movies online ?
@Easton Francisco Lately I have been using flixzone. Just google for it :)
Hi and thanks for the video.
Maybe you can make a video where they show the bpm stability ultra pitch with serato?
So with this ultra pitch, you can slow the rpms down, but not speed them up. Am I right?
what's shipping to Seattle, WA USA for this little bad boy?
Thanks for asking. 7 EURO for worldwide shipping.
Hi, it is mandatory the start/stop button to install the ultra pitch? Thanks
Thanks for asking. Yes it is. Alternatively you can bridge the terminal for the ultra pitch with a wire or solder.
@@PortablismGear thanks for answer, I bought the ultra pitch at your web, I didn't know that start/stop button is needed, it's possible to send to me the alternative instructions? 🙏 thanks in advance
@@kikebourton2541 sorry for the mistake. I thought you are asking for the 3in1 mod. My bad. Of course you can install the ultra pitch mod without a start/stop button. Please send us a picture of your open PT01 to ask@portablismgear.com and we will send an instruction to install it. The installation may vary depending on the mods already installed.
The music keeps coming off and on for some reason
Does it integrate with the Jesse dean stuff easily?
When using the JD Start/Stop kit, connect the middle cable of the ultra pitch to the white cable of the original switch and the right cable of the ultra pitch to the white/red cable of the original switch. That's it. Don't need to change anything else.
@@PortablismGear Thanks Portablism gear for the information but I did not understand everything so you need two crimps right? there is nothing connected to the start-stop plate board ??? thank you in advance & Big up Ramin and co
Tony Pichavant contact our support at ask@portablismgear.com and write us your actual setup. We will send you an installation guide.
@@PortablismGear Thanks you verry much
I got the 3 in one mod with the stop start and ultrapitch only. I’ve installed just the stop start button. What tupe of potentiometer do I need to use the ultrapitch connection?
Anyone know the Ohm rating of the pot by chance?
did you find the ohm ?
Unfortunately not. I'll pick one up and then I'll know for sure haha
@@KrisBarton432 🤣i put 100k but this dont work good
@@billybm7065 Good fop you for trying!!